Week…

                                                                                           WEEK…

Week 9 Challenge AIM: Create different connectors and attached the given components in an assembly using Hypermesh. BRIEF: Connectors are the geometric entities, which are primarily used to represent the CAD geometric connections in terms of FEA. Connections can be created as a spot-weld, seam weld, adhesive, bolts and…

                                                                                           …

                                                                Mid Surface Extraction and 2D shell meshing using Hypermesh. AIM: Meshing of the given Plastic component…

                                                                 Mid Surface Extraction and 2D shell meshing using Hypermesh   AIM: Meshing of the given…

                                                                      Week 3 - Solving second order ODEs using MATLAB AIM:  (1) Write logic…

                                                                              Week 4 - Genetic Algorithm in MATLAB AIM: To understand…

                                                                                      Week 4 - File Parsing…

                                                                               Project: Rankine Cycle simulator using MATLAB…

                                                                                 Week 2 Challenge in SIMULINK AIM: …

                                                                                      Week 4 Challenge in…

                                                             A system-level simulation of an all-terrain vehicle (ATV) in Simulink AIM: To carry out a system-level simulation…

                                                                                Week 3 Challenge: ADVISOR Tool AIM: To simulate…

                                                                       Wide Open Throttle (WOT) Conditions AIM: (1) To differentiate between…

                                                                                  Week 6 Challenge: EV Drivetrain AIM:…

                                                                               Week 7 Challenge: DC motor control AIM: (1)…

                                                                                        Week 11 Challenge:…

                                                                     Project 1: Powertrain for Aircraft in runways SOLUTIONS: (1) Search and list…

                                                                                 Project: Design of an Electric Vehicle…

                                                                  Understanding different battery chemistry (1) Prepare a table that includes materials &…

                                                        Week 7: State of Charge Estimation AIM: 1.Simulate the 3 test cases from the harness dashboard and write a detailed report on the results. 2.What is coulomb counting? Refer to the above model and explain how BMS implements coulomb counting for SOC estimation? SOLUTION:…

                                                   Mechanical Design of a Battery Pack Introduction: One of the fundamental components of an electric powertrain is the battery pack. The battery pack is the energy source for the vehicle, and for high-performance vehicles, it must supply energy to the vehicle at very high…

                                                                Car Crash Simulation Brief: A crash simulation is a virtual recreation…

                                                       Under-Body coating for Automobiles   Brief: Underbody coatings are those which are used to prevent car bodies against rust…

                                                            Base Bracket Design   AIM: To make a model from the provided class-A surface. INTRODUCTION: CLASS-A…

                                                            Butterfly Valve: Assembly AIM:- To assemble all the designed parts of the butterfly valve and apply GD&T to…

Design and Draft analysis of Switch Bezel design using CATIA v5   Aim: The objective of the project is to design the switch bezel and to do a draft analysis for it by creating the required tooling direction with the help of Bisecting method. Introduction: The control panel bezel is the frame part of the window switch…

                          Design and Draft analysis of Coin Holder design using CATIA v5   Aim: The objective of the project is to design the coin holder and to do a draft analysis for it by creating the required tooling direction with the help…

                                 CORE AND CAVITY DESIGN of Switch Bezel using CATIA V5 AIM:  To create the core and cavity blocks for the switch bezel component. DESCRIPTION: 1. PARTING LINE A parting line is an inevitable part of…