MESHING OF HOOD OF A CAR USING ANSA   AIM:    To create a mesh for the given hood of a car according to the given quality criteria using…

                                                   2D MESHING OF BOTTLE CAP USING ANSA     AIM:     To create a mesh for the bottle cap according to the given quality…

                                                                                           …

                                      AIM:     To perform connection's for a given FE model of the car with different connection technique's by using NASTRAN    THEORY:     REAR DOOR:…

                                                 MORPHING TECHNIQUES BY USING ANSA   AIM : To perform basic morphing technique for the given CAD model   THEORY :  Morphing…

                             AIM: To Extract mid surface and create the two-dimensional mesh for the given Instrumental Panel according to the given quality criteria by using ANSA  THEORY :    DASHBOARD :        …

                                   AIM: Perform 2D and tetra meshing and implement connections to the given car rear suspension model ABSTRACT: In this project will take half section of a car rear suspension system here will…

                                           AIM: CREATE A MESH AND 1D ELEMENT FOR THE GIVEN MODEL WITH CROSS SECTION AND DOF PROCEDURE:  Import IGES file to hyper work Create a mid surface Assign property…

  AIM: CREATE A MESH AND CLEAR ALL QUALITY ERROR'S FOR THE GIVEN MODEL PROCEDURE: Import file to hyperwork Delete solid surfaces Geometry cleanup Midsurface extraction Delete symmetry surfaces Defeaturing Assign quality criteria Meshing Quality error's cleanup IMPORT STEP FILE TO HYPERMESH Import the STEP file…

                                                                     AIM: To perform 3D Meshing on the given components by using either of the…

                                                                         AIM: To mesh the frame assembly and assemble the components with…

  AIM : To Extract mid surface, geometry clean up and create the two dimensional mesh for the given side door inner panel according to the given quality criteria by using HYPERMESH THEORY :  Door inner panel                             SIDE…

                                                                           AIM : To Extract mid surface, geometry clean up and…

                                                      AIM: To Extract mid surface, geometry clean up and create the two dimensional mesh for the given models according to the given…

                                                                     OBJECTIVE: 1. To check the Material Property for the given Starter File…

OBJECTIVE: Import the Starter file. Edit Run time and Anim DT. Run the analysis and plot the Graphs. In the second Case, change the recommended properties and run the analysis and plot for the same. Compare the two cases and state the difference in the results. PROCEDURE: CASE: 1 Import starter file Edit Run time and Tfreq…

                                        COMPARE ALL DIFFERENT CASES WITH DIFFERENT MATERIAL LAW'S OBJECTIVE: Compare all the seven cases with different material law's we further study the effect in the change of Failure…

                                     MESHING OF BUMPER AND RADIOSS INTERFACE AND STUDY OF EFFECT OF NOTCHES OBJECTIVE:  1.Mesh the bumper assembly model with an Element target size of 6mm. 2.Run the Crash tube…

AIM:  Frontal crash analysis, deck setup using hypermesh and hypercrash. OBJECTIVE:  To check the unit system and either follow [Mg mm s] or [Kg mm ms]. To create the appropriate interface, friction 0.2 and recommended parameters. To make sure of no penetrations and intersections. To correct rigid bodies if any…

AIM:  Side crash analysis, deck setup using hypermesh and hypercrash. OBJECTIVE:  To check the unit system and either follow [Mg mm s] or [Kg mm ms]. To create the appropriate interface, friction 0.2 and recommended parameters. To make sure of no penetrations and intersections. To correct rigid bodies if any…