Project 2

Aim:

Follow the below-mentioned quality criteria, mesh the component given below and assign thickness:

Target Element Length = 5mm

S.N	Quality Criteria	Value
1	Aspect Ratio	5
2	Skewness	45
3	Warping	15
4	Taper	0.5
5	Min. Length	2mm
6	Max. Length	8mm
7	Min angle Quad	45
8	Max angle Quad	135
9	Min angle Tria	20
10	Max angle Tria	120
10	Tria %	10

Solution:

After shifting all components into one collector we will do the defeaturing as shown below :

 Now we will divide the components into 4 sub parts using surface trim:

 Now we will move all these into separate collectors as shown below :

Part 1 : Left Bottom Corner

Now the mid surface for this bottom left part is made using the surface offset as shown below :

 We get the following Mid Surface :

Part 2 : Right Bottom 

Surface Cleanup:

As you can see some edges need to be cleanedup as shown above.

Now we will create mid surface as shown below :

Part 3 : Right Top 

We will create the mid surface of the top right part as shown below :

Now in the same way we will create the mid surface for the left top part as shown below :

 Therefore the whole part is given by :

Now we will be doing the surface clean up ny filling the empty surfaces:

The final mesh is as shown below :

Conclusion 

Hence the above part has been meshed