Tool Test 1

Aim :

Mesh the following components with following mesh criteria :

S.No	Quality Criteria	Value
1	Target/Average length	4
2	Minimum Length	2
3	Maximum Length	6
4	Aspect	3
5	Warpage	15
6	Skewness	45
7	Jacobian	0.7
8	Minimum Quad Angle	45
9	Maximum Quad Angle	135
10	Minimum Tria Angle	30
11	Maximum Tria Angle	120
10	Tria Percentage	15

Solution:

Cleaning the geometry :

Using the fix command we will remove these errors .

Creation of Mid Surface :

We will create mid surface of the main body as shown below :

Now the mid surface of the following components has been taken :

After using extend and the new surfaces commands various parts were joined to the main body as shown below :

Meshing :

Since our target element length is 4 mm , we will perimenter length command to make the distance between hot cons as 4 mm as shown below :

Setting the mesh quality criteria we get :

After meshing we get the following component :

Part 2 :

Automatic Geometry Cleanup :

Defeaturing Fillets :

Creating Half Surface :

The part is divided into half for meshing conveince as shown below :

The geometry cleanup has been done and now we will do the meshing after we set up the mesh quality:

After performing various commands such as mesh generation , copy about a plane and do a quality remesh we get the following :

Conclusion

Hence the above components have been meshed.