Motion Analysis Of Internal Geneva Mechanism Objective: To create 3D model of the internal geneva mechanism and to perform motion analysis. Given 2D CAD Drawings: Created 3D Models : Assembly : RESULTS PLOTS:  AT 10 RPM CONTACT FORCE BETWEEN DRIVER AND DRIVEN WHEEL: WITHOUT PRECISE CONTACT: WITH PRECISE CONTACT…

                                                          PLANETARY GEAR ANALYSISOBJECTIVE: To run the simulation of planetary gear having sun gear, a ring gear, carrier,…

                                                                                           …

                                                      MBD Simulation on IC Engine Valve Train Aim:  To model and assemble the parts of IC Engine Valve Train and perform motion…

                                                                                           …

                                                         Flow over a cylinder Aim: To perform the flow simulation over a cylinder as per given conditions. Introduction: The…

                                                                                1D Element Creation Objective: To Mesh the…

                                                            The meshing of Hood Challenge Objective: To mesh the given component by following mentioned quality criteria.  Theory: A car hood s the hinged cover that rests over the engine of a front-engine vehicle. Its purpose is to provide access to the engine for repair…

                                                   3D Tetra Meshing Challenge Objective: To Create the  Terameshes for given components using different methods. Problem specification: Create…

                                                                                    Week 9-Creation of 1D Connectors…

                                         Week 12:Project-1-Meshing of Door Inner Panel Challenge   OBJECTIVE:  To mesh the side door component and assign thickness. Quality Criteria: arget Element Length = 4 Units S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2…

                              Week 12:Project 2-Meshing of Rear Wheel Holder challenge Objective: To mesh the given component and assign thickness. Quality criteria: Target Element Length = 5 Units S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2 Units 6 Max. Length…

                                                                Assignment 1-2D Meshing Challenge   Objective: To Perform 2D meshing on given components.…

                                                                         Assignment 2-RADIOSS Engine File Editing & 3D Meshing Challenge…

                                                     2D Element Formulation Objective:  To simulate having a default property card and changing the property card and then compare the…

                                                                                          RADIOSS…

                                                                                           …

                                                                                                                    Frontal Crash Simulation Objective:- To perform frontal crash analysis in the neon model with the recommended parameters and output requests. Problem Specification:- Frontal crash-BIW Check unit system and…

                                                                        Side Pole Crash Simulation Challenge Objective:- To perform side pole crash analysis in the neon model with the recommended parameters and output requests. Problem Specification:-   Neon side crash -BIW Check the unit system and either follow [Mg mm…

Challenge Submission.

Challenge Submition

Challenge Submitted

Challenge submitted.

Submitted.

Submitted.