ASSEMBLING OF AMERICAN CHOPPER     OBJECTIVE                      …

    DESIGNING OF THE YATCH MODEL   OBJECTIVE               The objective of the extend is to plan and demonstrate all the parts of a predator yacht and amassing it to make the photo-realistic rendering of the yacht.   INTRODUCTION                         In this extend the Predator Yacht was taken as a conceptual show,…

                                                                                        REPORT WRITING…

                                                                                     REPORT WRITING  …

                                                                                    REPORT WRITING    …

                                                                                   FINAL REPORT CONTENTS …

                                                                                        REPORT WRITING…

                                                                                           …

                                                                                       REPORT WRITING…

                                                                                                REPORT WRITING  CONTENTS  TOOLING AXIS CREATION OF B & C SURFACE SOLID MODEL DOG HOUSE CREATION 4 WAY AND 2 WAY LOCATORS  HEAT STAKES DRAFT ANALYSIS CONCLUSION   TOOLING AXIS                         Tooling axis is the heading in…

                                                                                    report writing    …

                                                                                           …

 GIVEN CLASS A SURFACES   ARM REST    TOOLING AXIS   B SURFACE   C SURFACE   FINAL CLOSED SURFACE B SIDE FEATURES [ FLANGES] DRAFT ANALYSIS  TREE STRUCTURE   LOWER SUBSTRATE CLASS A SURFACE   TOOLING AXIS AND SIDE CORE AXIS B SURFACE   C SURFACE FINAL CLOSED SURFACE…

AIM: DETAILED REPORT ON BENCHMARKING         To plan a report clarifying what is Bench-marking , Compare at slightest 4 Vehicles and Give a Preoper conclusion for the report.  BENCHMARKING            It is the method of comparing one's commerce prepare and execution measurements to businesses bests and/or best hones from…

Underbody Coating  Underbody Coating may be a sprayable coating, which ensures the beneath surface of the vehicle from corrosion. Underbody coating gives long term assurance from erosion to car's underbody. It too secures parts like inside body boards, outline rails…

HOOD DESIGN introduction The hood or cap is the pivoted cover over the motor of engine vehicles that permits get to to the motor compartment for support and repair. Hoods are ordinarily made out of the same fabric as the rest of the body work. This may incorporate steel, aluminum, fiberglass or carbon fiber. In any case, a…

Aim :                    To calculate the section modulus of the already outlined hood for analyzing its quality additionally optimizing the plan to see the distinction within the bowing quality of…

Title:- Design Fender- Wheel Arch. Objective:-                        In this challenge to Calculate the Wheel Arc area and prove whether the car will pass the standards or Not.     Introduction:- Wheel Arch-                     It could be a half circle profile over wheels outlined for encasing tire inside the bumper The…

DESIGN OF FRONT FENDER   INTRODUCTION               Front fender may be a portion of the vehicle that outlines the wheel . the essential reason of the bumper is to anticipate sand , mud , shake etc from…

The component of an automobile that is located above the passenger compartment and shields the occupants from the sun, wind, rain, and other environmental factors is called the car top or roof.       INTRODUCTION :  every products design begins with requirements.the design engineer designs the…

Aim :                to develop the car bachdoor with the reference of given skin data as per engineering standard using NXCAD. Back Door : the back door is typically hinged but sometimes attached by some other mechanisumssuch as tracks in front of an opening which is used for entering…