BENCH-MARKING WITH THE PRESENT AVAILABLE CARS IN THE MARKET FOR THE FOLLOWING CASE AIM      To Bench-Marking with the present available cars in the market for the following case and to suggest Mr.Pughazhyendhii the best option to buy a car in his budget and conditions. WHAT IS BENCH MARKING? Bench-Marking…

                       UNDERBODY COATING   WHAT IS UNDERBODY COATING? Under body coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile.It is normally sprayed or painted on when the car is just…

                                                                  CAR HOOD DESIGN OBJECTIVE To design and model a passsenger Car Hood with outer panel,…

AIM Use the section from the Hood Design and calculate the Section Modulus, come up with a ne section that has improved the section modulus of the previous section and mention what change you made that has increased the strenght.                        SECTION…

                                                                            FENDER DESIGN INTORDUCTION Fender is a BIW component used as a frame for the wheel, th main purpose od afender in an automobile is to protect the engine compartment from sand, dust, small stones, etc which are thrwon into the air by the tire grip.…

                                                                   Fender Design - Wheel Arch AIM To decide whether the given design psses the european…

                                                                  ROOF DESIGN AIM The main aim is to determine the Heat Distortion criteria, Snow Load criteria,…

                                                                BACK DOOR AIM: Design of the car back door.   OBJECTIVE: 1. From the given styling surface,…

                                                                                  Switch Bezel Design  Aim  …

                                                                           Challenge 1 - Base Bracket Design OBJECTIVE To create base…

                                                                              Coin Holder Design   AIM:  To design…

                                                                                 Challenge 4 - Bumper  Objective:…

                                                                                          …

                                                                                          …

                                                                                          …

                                                                                           …

                                                                                   Assembly Workbench 1.…

                                                                                           …

AIM: To define Electrical properties of the given components. OBJECTIVE: To download the above CAD data of the parts from the given source. To define the Electrical properties correctly. To create catalogues of the components so that it can be used later. Introduction:  A connector is a device(or more precisely, a…

AIM:  To solve the above assignment questions and define the necessary electrical properties in the respective workbench. OBJECTIVE: To download the P-Clamp CAD data and define it as Electrical Support in the Electrical Part design workbench and also define the necessary electrical properties. To download the Backshell…

WIRE HARNESS ROUTING - WEEK 4 AIM: Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram. Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors…

Aim : Route the Given harness layout in Electrical workbench & Apply the Conditions. Ojectives : Check the bundle Continuity. Add snap of result in submission Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc Check for the bundle warning. Add snap. Generate CAT.part of harness…

AIM- To prepare a flattened-view of a previously created harness assembly OBJECTIVE- The objective of this project is to create a flattened-view for a harness assembly and then place it on the drawing sheet. It is desired that the bundles with protective coverings are represented with different visuals on the…

                                                                    WIRING HARNESS FOR ENGINE                …

Aim: To route the wiring harness on the given tailgate assembly and prepare the flatten view drawing in CATIA V5.  Given: Car Tailgate Assembly          DESIGN CRITERIA AND PACKAGING ASSUMPTIONS: Wiring harness routing shall provide ease in manufacturing, accessibility, easy removal,…