MODELLING OF CHOPPER IN SOLIDWORKS INTRODUCTION   The SOLIDWORKS Software   The SOLIDWORKS® CAD software is a mechanical design automation application that lets designers quickly sketch out ideas, experiment with features and dimensions, and produce models and detailed drawings. This document discusses concepts…

TITLE - MODELLING OF SUNSEEKER PREDATOR 108 YATCH IN SOLIDWORKS   INTRODUCTION   The SOLIDWORKS Software   The SOLIDWORKS® CAD software is a mechanical design automation application that lets designers quickly sketch out ideas, experiment with features and dimensions, and produce models and detailed…

Introduction to GUI based CFD using ANSYS Fluent       Mixing Tee Report       B A Mayur     Introduction The mixing of cold and hot fluids stimulates a variety of results. This stirs up the engineering of maintaining the approximate cold fluid inlet temperatures that mixes with…

Introduction to GUI based CFD using ANSYS Fluent       Flow Over A Cylinder- Report       B A Mayur     INTRODUCTION   For a moving object in fluid, there are normally four forces acting on it i.e., lift, drag, thrust and weight. Here the problem is focused on a stationery cylinder…

Introduction to GUI based CFD using ANSYS Fluent       Ahmed Body - Report - WEEK 3       B A Mayur     INTRODUCTION   An ahmed body represents a standard passenger car. It has a blunt rear region to simulate the wake region and the aerodynamics is such that it is sufficient…

Introduction to GUI based CFD using ANSYS Fluent       CHT of In-Line 4 Cylinder Exhaust Port - Report       B A Mayur     INTRODUCTION   An exhaust port is useful to vent out the gases post combustion of an internal combustion automobile.  Here, the geometry of an in-line…

Introduction to GUI based CFD using ANSYS Fluent       Mixing Tee Report       B A Mayur     Introduction   For free surface boundaries, the volume of fluid method is used to understand the interaction between two fluids of different phases. It is an important method to simulate…

Introduction to GUI based CFD using ANSYS Fluent       Graphics Card Simulation - Report       B A Mayur     INTRODUCTION   A graphics card comprises of a few electronic components, chips (processor) which is mounted on the base, circuits and fins utilized for heat dissipation…

Introduction to GUI based CFD using ANSYS Fluent       Cyclone Separator – DPM - Report       B A Mayur     INTRODUCTION   A cyclone separator is a device built to remove particulate matter whose size varies in a certain range above or below which they cannot be controlled…

Introduction to GUI based CFD using ANSYS Fluent       Gate valve Simulation – Parametric Study - Report       B A Mayur     INTRODUCTION   A gate valve is a control valve which is used to permit the fluid flow through a pipe. Depending on the level of the gate valve position,…

Report on Week 2 Challenge : Pressure Valve Meshing   B A Mayur   Aim: Surface mesh of a valve by performing a geometry clean up and generating faces where necessary.   Theory:   Every part must be closed to perform a meshing operation. Hence the single cons (red edges shared with one surface), double…

Report on Week 3 Challenge : Turbo-Charger Mesh   B A Mayur   Aim: Surface mesh of a turbo charger based on the required target length. Theory: Tria elements are polygons having 3 sides (edges) and 3 vertices. They are elements formed with 3 nodes. The element size is specified using the meshing tools. A model…