Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

AIM:
        DRAWING THE GIVEN ELEVATION AND SECTION USING AUTOCAD SOFTWARE.

DETAILS OF PROJECT:

THE GIVEN DRAWING CONSIST  KITCHEN ,SECTION OF ELEVATION DETAILS AND THE STEP BY STEP  PROCESS IS GIVEN BELOW.

THE GIVEN PROJECT IS ABOUT ELEATION OF THE BUILDING IN THE CHALNGE 7 AND A SECTION VIEW OF THE INDUSTRIAL BUILDING AND ALSO A KITCHEN PLAN OF BELOW AND ABOVE COUNTER PLAN.

PROCDURE:

STEP:1 (SET UP)

        For the given drawings the units are set according to the requirements.

The limits of the  page are set to 1000,1000 in x y directions respectively.

Dimention style commond is used to set the height of the text,arrow size an the primary units.units are set to engineering.

STEP:2(MODEFICATION)

Line commont(direct line system ) is used more frequently to draw the given lines as per the dimentions.

Circle with radius,circle with 2p method is used to draw the circles where it is required.

Tream option is used to tream the excess patrt of the  figures some times erase.

Dim tool is used to determine the dimentions of the lnes that are to be mentioned.

HATCH tol is used to fill the patterns.

Mtext is used to write the text on the sheet to specify the details of  the drawings.

Fillet is used to fill the corners where there are not joined corectely or disconnected.

Chamfer used to fill the corners with curved edges where they are to be joined with curved part.

F8 option is used for ortho,F9 is for snap

Hatch commond is used to fill the blocks with pattens and with colours to hilightg the thin.

STEP:3 ELEVATION 

HATCH TOOL IS USED TO GIVE COLOURS TO THE WALL AND DIFFERENT PATTERNS ARE USED OF HATCHING OF DIFFERNT  ITENS.