…

      INTRODUCTION          We are going to model a Sunseeker Predator Yacht  by using “ The SOLIDWORK ‘’ CAD software. Firstly  here we are going to model different parts of yacht like “ Hull “ ‘Rader” ”Super…

                                                                                           …

OBJECTIVE                 The main objective to design this is to familiar with different tools in NX CAD  software and what the process we are going to follow to get our output. Introduction         Here…

                                                                  WORK FLOW TO CREATE ODD SHAPES AND ANGLE OBJECTIVE                …

                                                                     Bracket Design OBJECTIVE                 The main objective to design this is to familiar with different tools in NX CAD  software and what the process we are going to follow to get our output. Introduction         Here we are going to create bracket …

% PROG. TO SOLVE 2nd ORDER D.E %INPUTS g=9.81; b=0.05; l=1; m=1; % INTIAL CONDITION t_span=linspace(0,20,20); a=[0,5]; %RESULTS CALLING THE FUNCTION PROG. [t,results]=ode45(@(t,theta)ode_func(t,theta,b,g,l,m),t_span,a) % PLOTING figure(1) plot(t,results(:,1); hold on plot(t,results(:,2); y label('plot') x label('time')…

                                                                        BENCH-MARKING  OF CARS WITH RANGE OF 8- 10 LAKHS AND SUGGESTION…

                                                                                           …

%concept of genetic algorithm and understanding the stalagmite function. %INPUTS ARRAYS X=linspace(0,0.6,150); y=linspace(0,0.6,150); [X,Y]=meshgrid(x,y); %returns 2-D grid coordinates based on the coordinates contained in vectors x and y % evaluating stalagmite function for i=1:length(X) for j=1:length(Y) inp(1)=X(i,j)…

HOOD DESIGN   The hood  or bonnet is the hinged cover over the engine of motor vehicles. Hoods can open to allow access to the engine compartment, or trunk on rear-engine and some mid-engine vehicles for maintenance and repair. It consists of outer and inner panel ,the inner panel provides…

Parsing NASA thermodynamic data Parsing Parsing a file means reading in a data stream and building a memory model of the content of that data. This aims at facilitating performing some kind of transformation on the data. Parsing splits a file or other input into pieces of data that can…

Fender Design Introduction Fender is the American English term for the part of an automobile, motorcycle or other vehicle body that frames a wheel well. Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Types Full bumper…

Section Modulus calculation and optimization Section modulus  Section modulus is a geometric property for a given cross-section used in the design of beams or flexural members. For general design, the elastic section modulus is used, applying up to the yield point for most metals and other common materials. The elastic…

DESIGN OF CAR ROOF Objective    Design an automotive roof based on given styling surface and to create front roof rail ,bow roofs, center roof rail and rear roof rail and to check manufacturability and feasibility of design. ROOF  An automobile roof or car top is the portion of an automobile…

DESIGN OF BACK DOOR Introduction It is the is the door at the back of vehicle also called as Tail gate.  Here we are going to develop car back door by following all design consideration with the given styling surface using NXCAD Tool. Components of Back door Back door outer upper panel Back door outer Lower…