MODELLING AND RENDERING OF AMERICAN CHOPPER ON SOLIDWORKS                                                  …

                               SUNSEEKER PREDATOR YACHT MODEL DESIGNING AND RENDERING                                            …

                        BOEING 747-8 AIRCRAFT MODEL DESIGNING AND RENDERING                                                      …

AIM:      Need to calculate the Reynolds number for given conditions and then increase it by a factor of 20%, 40% and 100% then run the transient flow simulation. Proper simulation end time for each case should be calculated. Finally Create animations for pressure-velocity for all the three Reynolds number…

AIM:      The purpose of this analysis is to find out and compare the lift and drag force over an airfoil for different angle of attack using flow simulation. INTRODUCTION:      Computational fluid dynamics (CFD) is a branch of fluid mechanics that uses numerical analysis and data…

AIM:      The purpose of this analysis is to create a 3D model of a bench flow and find out the pressure loss and mass flow rate in intake port of cylinder head of IC engine for different valve lift using solidworks flow simulation. INTRODUCTION:      Computational fluid dynamics (CFD)…

              CENTRIFUGAL PUMP DESIGN AND ANALYSIS BY FLOW SIMULATION IN SOLIDWORK’S   AIM:      The purpose of this analysis is to draw the performance diagram by create an approximate 3D model of a centrifugal pump and then find out the pressure ratio and mass…

                  SURFACE MODELLING OF AN ASTON MARTIN CAR USING SOLIDWORKS                                             …

                    MOTION ANALYSIS OF AN INTERNAL GENEVA MECHANISM AIM      Create 3D models for internal Geneva driven and driver wheels and perform motion analysis with different driver wheel speeds. Also using this speed difference find out the kinematic characteristic’s and obtain some plots. INTRODUCTION      One…

               PLANETARY GEAR DESIGN AND MOTION ANALYSIS IN SOLIDWORKS AIM      The aim of this project is to design the 3D model of planetary gear system with proper dimensions. Pitch circle diameter is one of the main features in transmission gear system. So,…

                 MOTION ANALYSIS ON A PISTON ASSEMBLY USING SOLIDWORKS AIM      To design the 3D model of piston, crank shaft, connecting rod and wrist pin with the help of proper drafting for each model. After that all part models are need to assemble and perform…

                        MBD SIMULATION ON IC ENGINE VALVE TRAIN AIM      To design the 3D models of cam, pushrod, rocker arm, valve stem and valve, and then assemble them to perform the multi body dynamic (MBD) simulation in solidworks. INTRODUCTION…

                                                                                       MBD Of Four Bar…

                                                                                          V6 ENGINE DESIGN AND RENDERING                                   SURESHKUMAR AIM      The purpose of this project is to know about the various components and its function using in engines. And design it by approximate dimensions which…

                                                                            FEA OF THREE TYPES OF BEAMS UNDER A BENDING LOAD AIM To…