1)TOOLING DIRECTION:  Intially,craete an dumming tooling axis along the midpoint of the circle.Then create a reference plane of yz along the dummy axis.Then intersect the reference plane with class A,the intersect shows the drafted line which might me a complicate during the modelling.So we need to create the correct…

CREATION OF TOOLINGAXIS: Intially select the measure inertia command in the toolbar.Then select the class A surface and then click OK.THen there is a soption called CREATE GEOMENTRY.it creates a geomentry witha point,In t his select a NON ASSOCIATIVE GRAVITY and click ok.Tyhen create a line at the point along the tooling…

Draft analysis: For draft analysis we need a tooling axis.after creating the tooling axis we need to check whether all the portions are cleared by the core and cavity.Minimum draft vangle is 3 deg to avoid the undercuts.So in draftvanalysis we put an angle of 3 deg. Parting surface: The surface where the two halves of…

DOOR TRIM-DOG HOUSE   AIM: To create the Dog House for the Door Trim considering the design rules   OBJECTIVE: The thickness of the part should be 2.5 mm.      Doghouse wall thickness at the intersection of the part wall ( C ) should be 40% or less than the main wall stock ( T ). …

DOOR TRIM-HEAT STAKES AND LOCATORS.   AIM: Create the Heat Stakes and the locators considering the design rules mentioned in the video for the door applique.    OBJECTIVE: The thickness of the part should be 2.5 mm.  Create the Door Trim Lower Plastic component through the given Class-A…

A PILLAR DESIGN WITH MATER SECTION   AIM: To design a pillar design using the master section curves   OBJECTIVE: Ensure using surface command. Use closed body command to create the solids   REPORT: DRAFT ANALYSIS: 1) It is a tool that allows the user to ‘see’ whether the part they are…

ASSEMBLY WORKBENCH   AIM: To create two assemblies with 2D diagrams of the components and to create the individual part files and then create a complete assembly of those part files in the assembly workbench Creation of drafting for the parts and assembly PROCEDURE: QUICK RETURN MECHANISM ASSEMBLY: CREATION…

I have attached the final project report and the zip file of CAT PART below.

BENCH MARKING:   Benchmarking is the process of measuring the performance of the competitor's products and their services which is available in the market.By analysing the pros and cons of the existing products, we improve our product to satisfy the customer needs. According to Mr.Pugazhendhi's need, When we decide…

UNDERBODY COATINGS:         Underbody coatings are used to prevent car bodies from rust & corrosion. It also helps in the protection from dust and moisture rocks getting thrown from tires and salt from water during monsoon which plays an important role in damaging the lowerside of the car. TYPES…

                                                                                           …

                                                                                           …

WHEEL ARCH  DESIGN   OBJECTIVE: To examine the given fender design to verify if the wheel arch of the fender meets the European standards. ABSTRACT: Fender is the part of a vehicle that surrounds the wheel. Apart from being the exterior aesthetic part of the vehicle, its important function is to prevent debris…

                                                                                           …

                                                                  ROOF…

                                                                                           …

                                           DESIGN OF BUTTERFLY VALVE  AIM: To model a butterfly valve and…