Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

OBJECTIVE:

ROUTE THE WIRING HARNESS LAYOUT IN ELECTRICAL WORKBENCH WHICH IS SHOWN BELOW IN THE PICTURE. ADD PROTECTIVE COVERING ON ALL THE BRANCHES AND KEEP THE EXTREMITIES AT 30 mm.

STEPS:

FIRST DEFINE THE PART AS THE CONNECTOR. AND DEFINE THE CONNECTOR CONNECTION POINT AND THE BUNDLE CONNECTION POINT FOR ALL THE CONNECTOR.

AFTER THAT STORE ALL THEM IN THE CATALOUGE. AND THAT IS DONE BY THE COMMAND STORE DEVICE .

CREATION OF WIRING HARNESS:

1. GO TO FILE , CHOSE NEW , AND THEN SELECT THE PRODUCT.

AFTER THAT CHANGE THE NAME IF YOU WANT,HERE I CHANGED IT .

AFTER THAT I HAVE ADDED NEW PRODUCT.

ADDED ALL THE CONNECTORS IN IT ONE BY ONE. AS SHOWN BELOW.

ADJUST THE CONNECTOR ACORDING TO THE DISTANCE , WHERE WE HAVE TO PUT THE CONNECTOR WITH THE HELP OF MANY COMMANDS LIKE SNAP, MOVE,TRANSLATION ROTATION.ALSO WITH THE HELP OF COMPASS.

THEN GO TO THE BRANCH DEFINATION COMMAND AND MADE THE BRANCH .

AFTER ADDING BRANCH POINT AND GIVE THE ROUTE TO THE BRANH.

AFTER THAT I HAVE GIVE THE PROTECTIVE COVERING WITH THE HELP OF THE CATALOUGE OF THE COT TUBES. AND GIVE THE PROTECTIVE COVERING TO ALL THE BRANCH.

AND GIVE THE EXTREMITIES TO THE END POINTS. AS SHOWN BELOW.