Wiring harness design in CATIA V5 - 3D modeling Week 7 Challenge

OBJECTIVE:

FLATTEN THE HARNES ASSEMBLY WHICH IS SHOWN BELOW IN THE PICTURE. PLACE THE FLATTEN VIEW ON THE DRAWING SHEET .ENSURE BUNDLE WITH PROTECTIVE COVERING HAS DIFFERENT VISUALS ON DRAWING VIEW.

FOR THAT FIRST WE HAVE TO DEFINE THE PARTS AS CONNECTORS, AND GIVE ELECTRICAL PROPERTIES LIKE DEFINING CONNECTOR CONNECTION POINT,BUNDLE CONNECTION POINT.

AFTER THAT STORE ALL THE CONNECTOR IN THE CATALOUGE.

AND PUT ALL THE CONNECTORS IN THE NEW PRODUCT FILE AND PLACE THE CONNETORS IN THE PLACE WHERE WE NEED IT. AND ROUTE THE WIRING HARNESS.

HERE I HAVE PROVIDED THE PROTECTIVE COVERING IN THE FLATTENING PRODUCT.

HOW TO START FLATTENING I HAVE DESCRIBED THE STEPS BELOW.

HERE WE CAN EXTRACTED THE ASSEMBLY IN THE FLATTENING PRODUCT FILE. AND WE CAN MODIFY IT BY USING COMMAND LIKE ROLL,ROTATE ,BEND ETC.

HERE WE CAN CHANGE THE PROPERTIES OF THE VIEW AND FLATTENING PARAMETERS .HERE WE CAN SEE ABOVE IN THE PICTURES SHOWN.