Week 8 - Challenge 2 - Switch Bezel Design

CREATION OF TOOLING AXIS AND THE SWITCH BEZEL FROM THE GIVEN CLASS A SURFACE.

CREATION OF TOOLING AXIS

(A) FIRST WE EXTRACT THE BASE SURFACE OF THE CLASS A SURFACE

(B) THEN WE DRAW A CENTER POINT ON THE EXTRACTED SURFACE.

(C) AFTER THAT FIRST WE TAKE THE REFERENCE FROM THE CLASS A SURFACE BY INTERSECTING THE CLASS A SURFACE WITH THE YC PLANE. AND AFTER THAT WE CONSIDER THE SURFACE PARALLEL TO THE TOOLING DIRECTION WHICH SHOULD BE CLEARED. AMD THENDRAWING THE TWO LINE AND THEN BISECTING THE LINE WE GOT FIRST LINE . FOR THE BISECTING METHOD TO BE PERFORMED FOIR THE TOOLING AXIS.

(D) AND THEN TO GET THE SECOND LINE FIRST WE INTERSECT THE CLASS A SURFACE WITH THE ZX PLANE.

(E)THEN BISECT THESE TWO LINE .

(F)THESE IS THE REQUIRED TOOLING AXIS.

DRAFT ANANLYSIS FOR THE CLASS A SURFACE.

DRAFT ANALYSIS OF THE SOLID PRODUCT.

SWITCH BEZEL