I. OBJECTIVES To build a program in MATLAB that could perform curve fitting of the Linear and Cubic polynomials for the given Temperature & Specific Heat, Cp data and plot them respectively. To calculate the Goodness of Fit of the curves. To write another program in MATLAB that can showcase…

   I. OBJECTIVES  To write a program that can optimize the Stalagmite Function and find the optimum Global Maxima for the same. To discuss the concept of a Genetic Algorithm as well as the use of syntax for ga in MATLAB. To plot graphs for all three studies and F maximum vs No. of iterations…

    I. OBJECTIVES To write a program that can parse the NASA Thermodynamic Data and extract the 14 coefficients and calculates the enthalpy, entropy, and specific heats for all the species in the data file. To calculate the molecular weight of each species and display it in the command window. …

    I. OBJECTIVES To generate a Midsurface and perform geometry clean-up on the given component. To generate mesh on the given component with low tria concentration and proper mesh flow. To ensure that the mesh passes all the given Quality criteria. To assign various thickness components to the model.…

   I. OBJECTIVES To generate a Midsurface and perform geometry clean-up on the given component. To generate mesh on the given component with low tria concentration and proper mesh flow. To ensure that the mesh passes all the given Quality criteria. To assign various thickness components to the model.…

    I. OBJECTIVES To carry out the Frontal Crash Analysis of a BIW for the given dummy dar model. To set up the model as per the below-mentioned case and ensure the correct running of the simulation. To extract all the output requests and the mandatory results and document the whole procedure with proper…

    I. OBJECTIVES To carry out the Side Pole Crash Analysis of a BIW for the given dummy car model. To set up the model as per the below-mentioned case and ensure the correct running of the simulation. To extract all the output requests and the mandatory results and document the whole procedure with proper explanations…

    I. OBJECTIVES To perform Geometry Clean-up of the surfaces of the given component. To extract the Midsurface from the component of the given model. To generate mesh on the given component with low tria concentration and proper mesh flow. To ensure that the model passes all the given mesh quality parameters…

    I. OBJECTIVES To perform Geometry Clean-up on the surfaces of the given component. To extract the Midsurface from the necessary component from the given model. To generate shell mesh and tetra mesh on the required components with proper mesh flow. To ensure that the model passes all the given mesh quality…

Final Project: Design of an Electric Vehicle     I. OBJECTIVES To create a MATLAB/Simulink model of an electric car that uses a battery and a DC motor using suitable blocks from the Powertrain blockset of Simulink. The report for the model shall be prepared including the following:   …

Project 1: Modelling of an Electric Rickshaw (3 Wheeler Passenger Vehicle)     I. OBJECTIVES To create a detailed MATLAB model of an electric rickshaw (three-wheel passenger vehicle) as per the details below:  Rear wheels driven by PM brushed type motor Assume efficiency points of motor controller…

Project 2: Modelling of an Electric Car with a Li-Ion Battery     I. OBJECTIVES To Create a MATLAB model of an electric car that uses a lithium-ion battery and a suitable motor as per the details below:  Suitable blocks to be chosen from the Simscape or the Powertrain block set. Implement…

1) simulate the 3 test cases from the harness dashboard and write a detailed report on the results.  Block of Model:- Test sequence Variant (it has 3 different test conditions) Manual Variant (selection) BMS_StateRequest subsystem to provide the state request commands. Indicating lamps are there to show any fault…