AIM:  to make a model from the provided class-A surface. INTRODUCTION: CLASS-A SURFACE: a surface made by the designer which is given as an input to the plastic modeler to work on. It is aesthetic surface and the outer most surface. CLASS-B SURFACE: a surface below a certain thickness from the class-A surface…

OBJECTIVE The objective of the project is to design the switch bezel and to do a draft analysis for it by creating the required tooling direction with the help of Bisecting method. INTRODUCTION The control panel bezel is the frame part of the window switch that holds its switch covers and buttons into place. Moulding is…

AIM          TO Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. Take the Thickness…

AIM Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.     INTRODUCTION A bumper is a structure attached to or…

OBJECTIVE The objective of the project is to design the switch bezel core and cavity to do a draft analysis for it by creating the required tooling direction with parting line and parting surface. INTRODUCTION The control panel bezel is the frame part of the window switch that holds its switch covers and buttons into…

Aim :    To create the Rib for the drill handle considering the design rules for rib creation and Screw boss creation and then perform the Draft analysis for the final component. Objective : Create the Tooling axis by using the bisecting method. Design the class-B and class-C surfaces and join them. Create the…

AIM Create the DOOR LOWER TRIM Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. Create the Heat Stakes and the locators considering…

 AIM: To create the dog house following the design principles SOFTWARE USED: CatiaV5. INTRODUCTION: DOG HOUSE Dog house is an engineering feature used in plastic trim design. Dog houses are used as supporting feature. Sometimes other engineering features like snaps; locators etc. are mounded on them to increase…

AIM The Aim of this project to develop A -piller a closed surface model by using of the master section and developed B side feature for locked the degree of freedom of the component. Here we can use B Pillar master section providing by the OEM Standards oftware used- CATIA V5. ABSTRACT-The report details about…

ASSEMBLE OF BUTTERFLY VALVE DRAFTING 3-2-1 Principle of Location The 3-2-1 principle of location (six point location principle) is used to constrain the movement of workpiece along the three axes XX, YY, and ZZ. This is achieved by providing six locating points, 3 pins in base plate, 2 pins in vertical plane and 1 pin…

AIM: Creation of CAD model considering following inputs as like in OEM and tier1 companies a) Class A surface b) Nominal thickness: Refer to master sections c) Attachment strategy :  Use Pushpin with Dog house for Lower substrate – Door panel attachment Use heat stakes for a part to the part attachment.  ABSTRACT: The…