Week 10- Assembly Workbench

AIM: Creation of CAD model considering following inputs as like in OEM and tier1 companies a) Class A surface b) Nominal thickness: Refer to master sections c) Attachment strategy :  Use Pushpin with Dog house for Lower substrate – Door panel attachment Use heat stakes for a part to the part attachment.  ABSTRACT: The…

ASSEMBLE OF BUTTERFLY VALVE DRAFTING 3-2-1 Principle of Location The 3-2-1 principle of location (six point location principle) is used to constrain the movement of workpiece along the three axes XX, YY, and ZZ. This is achieved by providing six locating points, 3 pins in base plate, 2 pins in vertical plane and 1 pin…

AIM The Aim of this project to develop A -piller a closed surface model by using of the master section and developed B side feature for locked the degree of freedom of the component. Here we can use B Pillar master section providing by the OEM Standards oftware used- CATIA V5. ABSTRACT-The report details about…

 AIM: To create the dog house following the design principles SOFTWARE USED: CatiaV5. INTRODUCTION: DOG HOUSE Dog house is an engineering feature used in plastic trim design. Dog houses are used as supporting feature. Sometimes other engineering features like snaps; locators etc. are mounded on them to increase…