SKETCH :-

CAT DRAWING IMAGE :- PDF IMAGE :-

FEATURE TREEE FOR SWITCH BEZEL CREATION :- SURFACE MODEL OF SWITCH BEZEL :- PART MODEL OF SWITCH BEZEL :- DRAFT ANALYSIS OF SWITCH BEZEL :-

DOOR ARM REST :- In this session created a Door arm rest part model by taking references as class A , class B and claas C. First with the reference of class A created a class B surface . Then created a claas C surface by taking boundary of class A. And then finally trim all the class A , B and c surfaces together get a…

DRIVER DOOR REPORT :- In this session created a door applique and dooor panel models for the given surface. First created solid body for the given surfaces and then created loctors and heat stakes on the door applique. Then in the Door panel, counter part referances are created by creating holes around the heat stakes…

B PILLAR :-                                                         Fig : 1                             …

DOOR TRIM PANEL :-   Door panels serve as an interface between the interior of the car and the inner workings of the door, and between vehicle occupants and the door. CLASS A INPUT SURFACES :- The given below model is the input surface model of the door trim panel. By using…

BENCH MARKING :- Benchmarking is a process of measuring the performance of a company’s products, services, or processes against those of another business considered to be the best in the industry, aka “best in class.” The point of benchmarking is to identify internal opportunities for improvement. By…

UNDER BODY COATING :- PVC UNDERBODY COATING :- WHAT IS UNDERBODY COATING :- In Indian road conditions, a cars underbody is most prone to corrosion. Underbody coating provides long term protection from corrosion to car’s underbody. It also protects parts like internal body panels, frame rails and other inner cavities…

OBJECTIVE :-  Design a Car Hood outer panel, Inner panel, Reinforcements by followiing master section references and consider all dimensions. PROCEDURE:- 1.Introduction  2. Assembly flow 3.Design parameters 4. Manufaturing considerations  5. Design approach 6. Cad approach 7. Conclusion 1.INTRODUCTION :-…

OBJECTIVE :- To Calculate the section modulus for the previously designed hood and optimized hood.To Come up with the new section that has improved section modulus of the previous section. INTRODUCTION :- WHAT IS SECTION MODULUS :- Section modulus is a geometric property for a given cross-section used in the…

INTRODUCTION  :- WHAT IS FENDER :- Normally rear fender has integrated with body whereas front fender is separate assembly component. This front fender is one of the side closest components to the engine compartment. The major function of this front fender is to avoid the chipping inside the engine compartment. In…

OBJECTIVE :- 1. For the given Car Roof styling, design and develop the essential flanges and reinforcements, namely the Ditch Area, Front Roof Rail, Rear Roof Rail, Centre Roof Rail and Bow-Roofs. 2. Do a curvature study on the roof and perform calculations for Heat Distortion and Snow load criterion to determine and justify…

OBJECTIVE :- For the given styling surface to come up with a back door design, use appropriate design methodologies and provide the necessary reinforcements and embosses. INTROUCTION :- Backdoor of a car is aso called tailgate. A car backdoor consist of inner pannel, 2-3 outer pannel & reinforcements. Car backdoor…