Computeing value of given voltage fileid1=fopen('C:\Users\USER\Downloads\VI.xlsx','r'); %value of given voltage VV =[-17.2 -17.1 -13.8 -13.5 -13.0 -12.5 -11 -9 -5.76 -6 -1 0.11 0.25 0.5 0.61 ]; %value of cureent from excel sheet current=[-17.2 -13 -11 -9 -6 -1 0.11 0.25 0.5 0.61 0.66]; c=interp1(VV,current); figure plot((-28:-14),VV,'o',current,c,'*');…

solution: Here the Speed control of a DC motor is either done manually by the operator or by means of an automatic control device. This is different to speed regulation where the speed is trying to be maintained or regulated against the natural change in speed due to a change in the load on the shaft so  the speed…

SOLUTION OF PROJECT Title: - Deals with the development of a forward energy-based fuel consumption model of a conventional vehicle. Aim: - 1] Build Simulink model using blocks and complete the vehicle model. 2] Writing scripts in MATLAB to load all the variables required for running the Simulink model. 3] Tabulate the…

As discussed in Lecture 11, Project 2 deals with the development of a forward energy-based fuel consumption model of a P1 hybrid vehicle. This model is based on the conventional vehicle model from Project 1. To do that, the following steps need to be followed: 1) Load the Project2 folder as the Current Folder in Matlab.…

PROJECT:               Analysis of a practical automotive wiring ciruit  Solution of this project  is in word file which is attached to the Answer body in both the formats word file and Pdf form   

Project  In this project we creat model of double-acting actuator using Simscape Multibody and Simscape components using this component from library the model of double acting hydraulic actuator system also in this model there are some subsystem which is mechanical system and cylinder assembly …

AIM: Download following connectors & Connector clip cad data from given link & define it as Electrical Connector using Electrical Part design Workbench. Define all the necessary properties to Connectors & Clip. Deutsch DT06 – 08SA ( https://www.te.com/usa-en/product-DT06-08SA.html) Tyco 174357-2 (https://www.te.com/usa-en/product-2-174357-2.html?source=header-match)…

Q1. Download following cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties. Steps. After downloading the file, use CATIA V5 to open it. In accordance with the part design model,entry,exit,base points, and planes are defined. Open the files in Electrical…

Q1. Route the following harness layout in the Electrical workbench. Make assumptions for harness bundle diameters. Use the Following connectors as shown in the layout diagram. Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end) Aim: 1)…

Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use the connectors provided. After completion of routing, Check the bundle Continuity. Add snap of result in submission Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc…

Q1. Flatten the harness assembly completed in “ week 4 challenge”. Place the flattened view on drawing sheet. Ensure bundles with protective coverings has different visuals on drawing view. AIM:- To prepare the flattened view of a previously created harness assembly OBJECTIVE:- This project's goal…