Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Q1. Route the following harness layout in the Electrical workbench. Make assumptions for harness bundle diameters. Use the Following connectors as shown in the layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

Aim: 

1) To Route the following harness layout in the Electrical workbench.

2) Add protective covering on all branches connected to DT06-2S & DT06-4S connectors.

3) Keep end extremity at 30mm (from connectors end)

4)Make assumptions for harness bundle diameters

Given:

CAD data of the following Connectors: 

.DT06-4S
.DT06-6S
.DT06-2S
.DT06-08SA

Convecting the Mechanical part design  into the Electrical part design for that I followed the below steps

the connector is shown below

part name: c-dt06-2s-a-3d

part name: c-dt06-4s-a-3d

part name: c-dt06-6s-a-3d

part name: c-dt06-08sa-b-3d

Reference are created on the front place for our easy arranging the connectors in the given layout

Layout is Created now we going to arrange our connector in an given order

Now Switch to electrical hardness assembly and create the multi- branchable segment

Cot-Tube is added to the product for each and every bundle to protect from heat and friction

The Final Connction shown below

here are the solution of above question and CATIA file is attached with answer body