Objective: To create a connector for the given model . CAD model: Procedure: Import the model. According to the given connector information select the part to be connected and hide the reamining parts. 1. Right_Rail_2 & Front_truss_1:- Seam-Quad(angled+capped+L) Hide the remaining parts and the mesh the surfaces…

Aim:To produce a tetra mesh for the rear mirror and check for the assigned quality criteria. CAD model: Procedure: Initally import the model to the software as it is an igs file Check the target element length and the give the perimeter size as 1 and even for the macros as 1 Then give a topo clean up and then save the…

time taken to complete the model is 3 hours

Aim: To produce a proper connection to the rear door of a car as per the given design. CAD model: Procedure: import the cad model to the ansa software check for the geometry and all other parameter and do the proper clean up hide the neccassary componets and check where the nut bolt connections are to be assigned go to…

 INTRODUCTION: Automotive susepnsion assembly is a part of car model which helps the body to avids shocks and helps in proper running of the vehicle.Here it is very important to anaylse the model with static and dynamic load.    The rear suspension of a vehicle performs the same…

Aim: To produce a proper mesh for the given component and assign proper thickness to each part. INTRODUCTION: Bottle caps are very nessaccary part in a bottle, as its going to handle the pressure and of the liquid that is present inside the bottle and avoid that bottle from bursting out. bottle caps have small ribs and…

Objective:To properly conduct a goemetry claen up, set proper quality criteria and mesh properly avoiding all the trias touching each other and no opposite tria in the component. PART1: Set up procedure: Initally import the model and then delete all the solids present it. check the thickness of the model at each and every…

 Aim: To create a proper hexa and tetra mesh fro the given component and edit the engine file0001.rad by entering the values after calculations. calcluations part: 1. Check the material properties of the rail component and calculate the speed of sound in steel rail=_______ Ans: The material property mentioned…

AIM: To analayse the material property and compare the results. Compare 7 cases as discussed in last 3 slides, in a tabulated format on the basis of: 1. Total number of cycles, Energy error, mass error and simulation time.2. Notice the animation of all 5 and describe the animations in brief on thebasis of whether…

1.Create the mesh for bumper assembly,mesh size should be 6mm import the model to hypermesh and then check for the solids present . PressF12-set the target element size and then click mesh. lower part of the model is meshed and the upper has to be connected with each other by using F11 mesh the upper part and then save…

A crash test is a form of desrtuctive testing usually performed in order to ensure safe design standards in crash worthiness and crash compatiblity for various modes of transportation or related systems and components Abstarct:  An automoblie(car body structure) was designed and analyzed which can be used for travelling…

A crash test is a form of desrtuctive testing usually performed in order to ensure safe design standards in crash worthiness and crash compatiblity for various modes of transportation or related systems and components   Abstarct:  An automoblie(car body structure) was designed and analyzed which can be used for…

Aim:To anaylse the stress concentartion a plate with hole  Case1: Open the ansys workbench,set the dimension to mm,kg,KN. Select structural analysis>>set up engineering data by selecting the material required for the part>>right click on geometry>>open spaceclaim>> create a diagram according…