ADVISOR TOOL

AIM To perform shell meshing and also volume meshing along with the necessary connections for the given Suspension system model. OBJECTIVE :        For the given assembly, check for the geometrical errors and mesh with the given element Quality criteria. After meshing the component the thickness has to be assigned for…

  AIM: Pre-processing of the car instrument panel using ANSA OBJECTIVES:-  Introduction to shell meshing or 2 D meshing. Topological errors and geometry errors clean-up. Extracting mid surface with a different method. Meshing the geometry within quality parameters. Rectifying quality errors i.e. solving off elements. Improving…

Aim: For the given rear door FE model, chose a certain type of element for connecting certain parts of the door.   Procedure:   The model has only one PID in the beginning so I have created PID for all the parts in the door.     Now to create a connection start with the sides of the door because there…

AIM: To create a 2D mesh in the Rear-wheel holder component according to the quality criteria, and apply thickness to the mesh. QUALITY CRITERIA: S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2mm 6 Max. Length 8mm 7 Min angle Quad…

AIM: To create a 2D mesh in the side door plastic component according to the quality criteria, and apply thickness to the mesh. QUALITY CRITERIA: S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2mm 6 Max. Length 6mm 7 Min angle…

OBJECTIVE: To mesh the back door geometry of the car with the given element Quality criteria, check for geometry clean up with no topological errors and mid surface extraction. QUALITY CRITERIA: S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5…

OBJECTIVE:       To mesh the Hood of the car with the given element Quality criteria, check for geometry clean up with no topological errors and mid surface extraction. QUALITY CRITERIA S.NO QUALITY CRITERIA VALUE 1 Target/Average length 5 2 Minimum Length  2 3 Maximum Length    7 4 Aspect…

AIM: Roof crash analysis using Radioss and hypercrash OBJECTIVE: Arrange the position of the impactor and simulate a roof crash with suitable interfaces. create impactor boundary conditions to guide the master node of the impactor rigid body so that it is free to translate normally to the face of the impactor,…

AIM:  To perform tetra elements meshing for the rearview mirror component and there should not and kinks and dips on the surface of the component. PROCEDURE: Import the model to ANSA software. it consists of a supporting part, a rotating ball, a mirror base, a mirror interior.            …

AIM:           Frontal car BIW structure crash analysis using hypermesh/ radioss. OBJECTIVE: Check the unit system and either follow[Mg mm s] or [Kg mm ms]. Create an appropriate interface, friction 0.2, and recommended parameters. Make sure of no penetrations and intersections. Correct rigid bodies…

AIM: Side crash analysis simulation using hypermesh/ Radioss on the car BIW structure. OBJECTIVE: Check unit system and either follow [Mg mm s] or [Kg mm ms]. Create an appropriate interface, friction 0.2, and recommended parameters. Make sure of no penetration and intersections. Create a rigid wall with friction…

CHALLENGE 1: For EV_defaults_in file, if cargo mass is 500 kg with all other default conditions, can the vehicle travel for 45 km with FTP drive cycle? Conclude your observations. ADVISOR : Advisor means that advanced vehicle simulator. It is designed for rapid analysis of the performance and fuel economy of conventional,…