AIM: To simulate the given data and conditions for an EV using Advisor Tool in MATLAB.      Objective:                 1. Using EV_defaults_in file, if cargo mass is 500 kg with all other default conditions,…

                                                         Data Handling and Interpolation   Aim of objective:                In a laboratory experiment, data of voltage and current has been recorded and the same is attached in an                          excel file ( Click on this link VI.xlsx ). Read the excel file in…

  Q.1)What is the difference between mapped and dynamic model of engine, motor and generator? How can you change model type?       MAPPED MOTOR:-  It makes use of lookup tables and the values should be pre defined.  Simulation time is less.  The results obtained will not resemble…

   Q-1)  Which types of power converter circuits are employed in electric and hybrid electric vehicle?       What is Power Electronics ?                                        …

 Q-1)        A)  Explain a MATLAB demo model named ‘Speed control of a DC motor using BJT H-bridge.                                           An H-bridge is an arrangement…

Q-1)  For a defined driving cycle, calculate the energy required for braking For a defined driving cycle, calculate the energy required for braking    At first, the drive cycle is determined in a Table and a plot is made. Using the plot, the values from the braking regions of       the…

Q-1)  Search and list out the total weight of various types of aircrafts.  1. LIST OUT THE TOTAL WEIGHT OF VARIOUS TYPES OF AIRCRAFTS: The aircraft gross weight (also known as the all-up weight and abbreviated AUW) is the total aircraft weight at any moment during the flight or ground operation. An aircraft's…

 AIM:To create an electric vehicle model using MATLAB / SIMULINK OBJECTIVES:         1. System level configurations        2. Model parameters        3. Results        4. Conclusion What is an electric Vehicle? An electric vehicle (EV) is one that operates on an electric motor, instead of an internal-combustion engine…

Q-1) Obtain the transfer function of a mass spring damper system and use it in the model. Add a PID controller to adjust the force on mass so that its position follows a reference signal. Take m = 3.6; %kg k = 400; %N/m c = 100; %Ns/m The reference signal is shown in the following figure.  AIM :-  …