AUTOMOTIVE BENCHMARKING Benchmarking is the process of comparison of similar products on some dimensions of performance Automotive Benchmarking is the process of analyzing the choices of similar products based on the selection factor and deducing it to final conclusion. CASE Mr. D.S. Pughazhyendhii is a married man…

Underbody coating: It is nothing but the safety of every vehicles underneath body by coating applied to the underside of a vehicle to protect it from rust corrosion and abrasion.  The underbelly of the car suffers more than the rust and corrosion there are the numbers of factors that should be considered. Undercoating…

Aim:Designing the Hood Outer Panel, Inner Panel and with the necessary reinforcements like emboss & hinges by following the Master Section with the Design parameters. Objective: A detailed report about the Hood Design which includes a detailed explanation about hood and its components, Latch Trajectory, Mastic Data, Emboss…

AIM : To design the mountings on the different sides of the fender skin given by the aesthetic developer. objective : The aesthetic part fender wheel is given on that we got know how to place the mountings on drip area, bumper area, buffel area and the Sil areas and to create the emboss on the flat surface to mount…

                                                                      Section Modulus AIM :To generate the report on finding the section modulus…

FENDER DESIGN - WHEEL ARCH CALCULATION:   OBJECTIVE:Calculate the Wheel Arc area of European Standard and prove whether the car will pass the standards or Not. Introduction to wheel arch of a car: The wheel arch is an arch-shaped cavity in the body of a vehicle, which houses a wheel. It has two important functions.…

Roof Design: Objective: For the Given Roof styling, create an ASSEMBLY by developing the essential flanges for the outer roof and creating the reinforcements.Provide appropriate dimensions and check for Draft analysis.Do a curvature study on the roof and perform calculations to determine the position…

A PILLAR DESIGN: AIM: To design A -PILLAR , from the given input mastersection and CLASS A surface. OBJECTIVE: The main objective of the project is to create a solid body from the given class A surface and the master sections, and performs draft analysis in the various stage of design A SURFACE which is the aesthetic…

 Design of Door Trim Lower with Engineering Features: AIM: Create the Door Trim Lower Plastic component through the given Class-A surface. OBJECTIVE: To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft…

QUESTION: create the individual part files and then create a complete assembly of those part files in the assembly workbench. After creating the assembly make use of the drafting tools to create a 2D drawing similar to the one given in the assignment folder.  QUICK REURN MECHANISM: 2-D DIAGRAM OF QUICK TRIM: 3-D DIAGRAM:…