BENCHMARKING :  Benchmarking in the automobile industry involves a structured comparison between similar products, services or processes on some dimensions of performance. In other words it is the comparison of products which are already there in the market and any positive points that I can improve to my design to…

UNDER-BODY COATING: Vehicle's underside serves as an intermediate between metal components of a vehicle and outer environment. Underbody of vehicles is prone to damage due to harsh environmental conditions. Coatings are applied to the underside of the vehicles to protect them against factors such as corrosion, chemicals,…

OBJECTIVE Design hood outer panel, inner panel and reinforcements with the given outer hood skin, master section and design parameters. INTRODUCTION The hood or bonnet is the hinged cover over the engine o motor vehicles. Hoods can open to allow access to the engine compartment ( or trunk on rear-engine and some mid-engine…

SECTION MODULUS OF A HOOD Section modulus is a direct measure of strength of any sectional area of an object about an reference axis(neutral axis). Strength is nothing but, capable of supporting greater loads, so higher the strength it has a high capable of supporting greater loads. This strength can measured directly…

FENDER Fender is a part of an automobile, motorcycle or other vehicle body that frames a wheel well ( the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Fenders are typically and can be damaged by contact with road…

OBJECTIVE : To design the car Front Fender according to the given design parameters related to industry standards.  FENDER : Fender is a part of the vehicle hat frames the wheel. Its primary purpose is to prevent sand, mud, rock etc from being thrown away in to the air by rotating tire. The part the car covering the wheel…

                                             CAR ROOF DESIGN OBJECTIVE :  The objective of this project is to design car roof with essential flanges and reinforcements like ditch area, front roof rail,…

                                                          DESIGN OF BACK DOOR Objective: To design the backdoor of a  car with the A-surface provided using the proper…

                                                                          BASE BRACKET DESIGN  AIM This Report  aim is to perform…

                                                                         SWITCH BEZEL DESIGN   OBJECTIVE:  This Report objective…

                                            CORE AND CAVITY DESIGN FOR SWITCH BEZEL OBJECTIVE:  This Report objective is to create the Core and cavity design of the switch bezel component that we designed…

                                       COIN HOLDER DESIGN  AIM This Report aim to create a tooling direction of the given class-A surface of Coin Holder and then to create the solid model by creating B and C surfaces…

                                                    BUMPER DESIGN  AIM This Report  aim is to perform draft analysis for the given surface by defining a tooling direction appropriate…

AIM This Report  aim is to perform draft analysis for the given surface by defining a tooling direction appropriate to the shape of the surface and also to create the class-B,class-C surfaces and final closed body with the help of given Class A surface of Door trim lower and to create heat stakes and 4 way loactors…

                                     QUICK RETURN MECHANISM First we have to create all parts and then assemble those to get quick return mechanism. 1.SLIDER LINK 2.FIXED SUPPORT 3.SLIDING BLOCK   4.SLIDER 5.PIN ASSEMBLY…

                             DOOR TRIM PANEL OBJECTIVE  This project objective is to create fully developed solid bodies for all the given door trim components and add the necessary commodities to assemble all the part bodies using CATIA v5.…

  OBJECTIVE:  The objective of this project is to design the assembly of the Butterfly valve and apply the GD&T concepts to the various parts of the Butterfly Valve and to the assembly. Butterfly Valve:- A Butterfly valve is a quarter-turn rotational motion valve, that is used to stop, regulate, and start…