OBJECTIVE: Designing a plate with a single hole or several holes, simulating the two scenarios, and comparing the results of its deformation and maximum stress are the goals of this assignment. Additionally, it is necessary to conclude which of the two circumstances will favor analysis and which scenario will favor the…

AIM: To perform static structural analysis on a pair of spur gears made of various materials in order to calculate equivalent stress, total deformation, and stress intensity and compare the findings.   OBJECTIVE:  i. To conduct static structural analysis on a pair of spur gears made of cast iron (ductile) and determine…

  Aim :          To analyze and compare the results for the given different mesh sizes of the same material using ANSYS software.   OBJECTIVE To describe the Grid Dependency test and its uses To perform Static Structural analysis on a Bevel Gear in ANSYS Workbench and perform Grid dependency test with three different mesh…

 AIM:            Simulate the rail wheel and track for their lifecycle and the stress, strain, and total deformation provided by the wheel  running on the track by the given forces  OBJECTIVE: The objective of this challenge is to perform a static structural analysis on the…

AIM: To compare the findings of static structural analysis, such as directional deformation, stress, and strain development on welded joints, on welding joints made of three distinct materials. OBJECTIVE: Case 1.  Stainless Steel: In this case, the material of the plates must also be the same. Use Stainless steel…

AIM:  To perform a static structural analysis on sheet metal bending using three different materials (copper alloy NL, magnesium alloy NL, and aluminum alloy NL) and compare their results in terms of directional deformation, equivalent stress, and equivalent strain. Additionally, play with different frictional coefficient…

AIM:            To simulate the rolling operation on a workpiece made of copper.   OBJECTIVE:    For this analysis, an ingot composed of copper alloy will be utilized. Two rollers will be rolled so that the ingot passes through them and, under pressure, deforms…