OBJECTIVE The main objective by modelling this brand new Chopper is to learn Solidworks environment and the commands utilized for constructing Chopper. DESIGN PROCESS The building of this chopper was started with the modelling of transmission belt and went on further part by part. MODELLING The modelling of parts of American…

OBJECTIVE The main motto of this project is to learn various techniques invloved in modelling a finest Sunseeker Yacht. Unlike gas tank in chopper, surfce modelling was frequently used to bring up this yacht. Parts like Super structure, Radar mast, Radar, Garage, Seats, Hull, Propeller were modelled under this project.…

Here I have attached models for week2 challange.

INTRODUCTION BAR ROD & BEAM Loading conditions plays a important role between bar rod and beam. A bar and a rod can be only subjected to axial loads like tension or compression, whereas beam can be subjected to any types of load like tension, compression, torsion, and bending.  MIDSURFACING Midsurface is 2D element,…

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                           …

OBJECTIVE The main objective of this challange is to do the following for the given model. Clean the geometry. Extract midsurface. Clean midsurface geometry. Create 2D mesh with target length 5mm, min 3.5mm max 7mm. And assign proper thickness, by creating a generic property. PROCEDURE: MODEL 1 : STEP1) Do check for…

AIM: To process the 2D 1D and 3D mesh on the given model and understand the meshing concept strongly Procedure: 2D Meshing of ARM BRACKET: STEP 1) Check for the solids in the model, if any delete the same using delete option.                                                                                        Figure…

AIM & OBJECTIVE: The main idea is to run the simulation of a crash beam and to introduce the element properties and compare the results obtained from the both. PROCEDURE: STEP1) Change the user profile to Radioss block.                          FIG 1. USER PROFILE STEP 2) Import the model using Import solver deck option.…

                                                                                           …

OBJECTIVE: The manin objective of this challange is to understand the concepts of interface contacts and its application. Also apply the same to the given model by making some changes as given below and study the effects. Create the mesh for bumper assembly,mesh size should be 6mm.  Run the crash tube model as it…

                                                                                           …

                                                                                                               SIDE CRASH ANALYSIS WITH NEON DODGE MODEL   AIM: The main aim is to perform side crash analysis in the neon model with the recommended parametres and output requests. Check unit system and either follow [Mg mm…