Concept of Underbody Coating                                       Basically, underbody coating is a type of defensive layer that’s applied to the undercarriage of vehicles.  It is usually a desnse cladding (often based on rubber) applied uniformally to the undercarriage…

Hood Design Challange-Using NX CAD Aim: To design the hood of the car using NX CAD Objective: To design the outer panel from the given styling surface according to the Euro-New Car Assessment Program. To design the inner panel with respect to the given styling surface as well as considerng the design of the outer panel…

Fender Wheel Arch Report Objective: To calculate the Wheel Arch area and prove whether the car will pass the Europian standards. What is a Wheel Arch? Wheel Arch is the semi-circular part of the fender positioned above the wheel of the vehicle. The wheel arch of a fender should be designed in such a way that it must acts…

Fender Design:  Fender is a part of a vehicle that frames the wheel along with protecting the engine compartment against sand, mud, rocks, liquids and other road spray from being thrown into the air by rotating tyre. Tyes of fender: 1. Full Bumper  2. Half Bumper figure 1 Types of Fender  Objectives: …

Section Modulus Calculation And Optimization Aim: To calculate the section modulus of the previously designed hood for analysing its strength and then optimizing the design to increase the section modulus ultimately increasing the strength of the hood.  Section Modulus: Section modulus is a geometric property for…

Roof Challange Report Aim:  To develop essential flanges and reinforcements for the given styling surface. To conduct draft analysis To conduct Section Inertia Analysis on the O-Y section To do a curvature study on the roof and do necessary calculations Introduction: An automobile rood is the portion of an automobile…

Back Door Challange Aim: To design a back door of a car by using the given styling surface. To provide necessary reinforcement and embosses. Introduction: A back door or tailgate is the rear side of a car which gives access for the boot space to store luggage, spare wheel, etc. These doors can be operated manually or electric…

Title Of The Project: Concept Modelling Of Alloy Wheel Objective: To build surface for the given alloy wheel blueprint. Introduction:  A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived…

Title Of The Project: Concept Modelling Of Car Bumper Objective: To build the surface for the front bumper of the car. Introduction: A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived by…

Title Of The Project: Concept Modelling of Side Fender Objective: To build the surface for the side fender. Introduction:  A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived by an observer…

Title Of The Project: Concept Modelling of Steering Wheel Objectives: To build the Surfaces for Steering Wheel. Introduction:  A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived…

Title of the Project: Concept Modelling Of Seats Objectives: To build the surfaces for the seat. Introduction: A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived by an observer using the…

1. Title of the Project: Technical Surfacing Kia Sportage 2. Objective: To build the surfaces of the Kia Sportage 3. Introduction: A surface, as the term is most generally used, is the outermost or uppermost layer of a physical object or space. It is the portion or region of the object that can first be perceived…

Title of the Project: Rendering Project These are the rendered images of one of my challenges: