Photo Realistic Rendering

MODELING, ASSEMBLY and PHOTO REALISTIC RENDERING OF AN AMERICAN CHOPPER

OBJECTIVE:-

To create part drawings, To create 3D models, To assemble the created parts.
To Create a photo-realistic rendering of an American Chopper using Photoview-360 in Solidworks.

INTRODUCTION:-

            American chopper was a famous motorcycle in America from the 90s. This is the custom bikes that we are going to model in Solidworks.

Flow chart:-

COMPONENTS MODELLED
1.Transmission belt :

Features used - Offset, Fillet & Boss Extrude.

2.Fenders :

Features - Revolve, split, and fillet

3.Kickstand:

Features - loft, dome

4.Chain:

Features -curve driven pattern, boss extrude, block

5.Oli tank:

Features - Boss extrude, shell, combine, fillet

6.Pedal:

Features - are Boss extrude, fillet, linear pattern

7.Front wheel:

Features - Revolve Boss, Boss Extrude, Cut Extrude, Fillet, Chamfer, Mirror & Circular Pattern

8.Rear wheel:

Features - Revolve Boss, Boss Extrude, Cut Extrude, Fillet, Chamfer, Mirror & Circular Pattern

9.front fork:

Features - Boss Extrude, Revolve, Sweep, Projected Curves, Composite Curves, Shell, Dome, Mirror & Linear
Pattern

10.chassis:

Features - Boss Extrude, Revolve, Sweep, Mirror, Fillet, Chamfer & Projected curves

11.Engine:

Features - Boss Extrude, Cut Extrude, Revolve, Sweep, Projected Curves, Composite Curves, Fillet, Chamfer,
Mirror, Linear Pattern & Circular Pattern

12.Gas tank:

features - Surface Fill, Boundary Fill, Surface Sweep, Extrude Surface & Projected Curves.

 Rear view

Camera view

 Isometric view

 Front View

Top View

 Side View

CONCLUSION

I have concluded that I have successfully designed the model & done assembly and also learnt to render the model using photo view 360.