AIM:-         To prepare the report for bench marking  and how is it work on competitive   world and also I do the suggestion by using the benchmarking in Mr. D.S. Pughazhyendhii family. What is Benchmarking ?         It is the process of comparing one's business process…

AIM:-                 In this project , I’m going to work on the underbody coating process, types, advantage & dis advantages What is  underbody coating ?                Underbody coating provides long term protection from…

AIM:-                 In this project , to do the  hood design of BIW  using  given  master section drawing and follow the design parameter hood like opening angle, NVH, safety HOOD :-                   …

Aim:-             To find the section modulus of the hood and optimization to improve the overall section modulus. Section modulus:-                section modulus is a geometric property for a given cross-section used in the design of beam and flexural members. by finding the section modulus we can find the resistance…

AIM:-            Calculate the Wheel Arch gap at required points and check whether the car passes the European standard.  WHEEL ARCH:-              The wheel arch is the semicircular part positioned above the wheel of a vehicle. The most important body change was that the front wheel arch was cut higher into the fender.…

AIM: -                To design a  front fender of a car by following the given master section as per the design considerations of OEM. FENDER:-                  …

AIM:-             To develop the essential flanges of roof(front ,rear ,bow ,center roof) and checking draft by performing Draft analysis as well as Calculating Heat distortion and Snow load on the roof Roof:-          …

AIM:                  To design the back door of the car and  make the inner panel for the back door and also design the necessary mounting prats like latch and  striker reinforcement, hinge reinforcement, wiper reinforcement, gas stay reinforcement Introduction of back door\tail gate:-                 A door is a hinged…

1.QUICK RETURN MECHANISM Initailly each body create seperate file as per given dimension in drawing  like below mention image , body1 body2 body3 body4 body5   finally each body create to assembly with respective constraint, as per manufacture purpose create 2d drawing,   2.CV JOINT Initailly each body create seperate…