MODELLING OF BOEING 747-8 USING SOLIDWORKS OBJECTIVE: The main objective of this project is to sketch and model a Boeing 747-8 aircraft using SolidWorks in a part modeling and surface modeling environment and then assemble the individual parts using SolidWorks Assembly Environment. PARTS MODELED IN BOEING 747-8: Fuselage…

1. Aim Simulate the flow over a cylinder in which external simulation takes place. Run a baseline simulation and then calculate the Reynolds number. Then increase the number by 20%, 40%, and 100% then run the transient flow simulation.  Animations of pressure-velocity for all three Reynolds numbers are created. 2.…

1. Aim: To model the flow over a NACA0017 airfoil and compare the lift and drag forces for the angle of attacks 0,2,4,6,8,10. 2. Introduction: The NACA airfoils are airfoil shapes for aircraft wings developed by the National Advisory Committee for Aeronautics (NACA). The shape of the NACA airfoils…

SURFACE MODELLING OF ASTON MARTIN ONE-77 USING SOLIDWORKS OBJECTIVE: The main objective of this project is to surface model all the parts of the Aston Martin One-77 and assemble and create it for Photo-Realistic Rendering. INTRODUCTION: The Aston Martin One-77 is a two-door, two-seater flagship sports car built…

1. Aim Create a 3D model of a flow bench.  Run parametric study on different valve lifts. Run flow analysis and obtain a plot of lift vs mass flow rate. 2. Introduction Computational Fluid Dynamics (CFD) Computational Fluid Dynamics (CFD) is the analysis of fluid flows using numerical solution methods. Using CFD, you are…

1. Aim: To create a 3D model of a centrifugal pump. Plot difference between pressure ratio and mass flow rate. 2. Introduction: Centrifugal Pump: A centrifugal pump is a mechanical device designed to move fluid by means of the transfer of rotational energy from one or more driven rotors, called impellers. …

Modelling and Rendering of an American Chopper Aim: To sketch and design the parts of the American chopper using Solidworks. To assemble the modeled parts of the chopper by using the Solidworks assembly environment. To create photorealistic rendered images of the chopper using Solidworks visualize.  Introduction:…

        Project Report Modelling and Rendering of Sunseeker Predator Yatch Aim: To sketch and design the parts of Yatch using Solidworks. To assemble the modelled parts of the chopper by using the Solidworks assembly environment. To create photorealistic rendered images of the yatch using Solidworks…