Modelling of American Chopper in Solidworks Introduction: Solidworks is one of the prominent modelling software available. This software is mainly used to model 3D parts using 2D sketch. It also has the option to specify the material and look for the model which we create. It has other Add-in features like photoview360…

Report on Sun Seeker Predator Yacht   Objective:   To design individual parts of the yacht with fully defined sketches and appropriate appearances. To assemble all the individual parts of the yacht model by assigning suitable constraints. To render the yacht model by adding appearances, decals, lights, cameras,…

MODELLING OF BOEING 747-8 IN SOLIDWORKS Aim and Objective: To sketch and model every exterior part of the Boeing 747-8 Aircraft under the part modelling and surface modelling environment using the Solidworks. To assemble the modelled parts in the assembly environment. To create a photo realistic rendering of the Boeing…

Challenge 6Introduction: This challenge involves creating material properties, defining loads, boundary conditions and applying constraints to the tension fitting geometry developed in the previous challenge.Objective: The primary objective of the class 6 Challenge is to demonstrate the ability to set up material properties,…

Butterfly ValveAim: The aim of the project is to assemble a butterfly valve using the individual parts created using NX.Procedure:1. Create a new assembly tab in Nx and create a new assembly.2. Go to insert components feature and insert all the individual components to the assembly module.2. Now rather than mixing all…

Switch Bezel DesignDraft AnalysisWhen manufacturing any plastic component, a draft angle is incorporated into the design tapering each side from the base to an angle slightly less than 90 degrees. This design feature ensures that the molded part can be easily removed from the mold after the molding process. Without a draft…

Challenge 3 - BumperAim: Create the bumper plastic component through class A surface and then perform draft analysis.Theory:Class A Surface: Class A surface is a surface made by the designer specifically in automotive design which is the aesthetic part of the body and given as input to the plastic designer to work on it.Class…

Assembly WorkbenchAim: Create a 3 D parts from the given 2D drawings and making an assembly of it then create 2D Drawing of the created 3D parts in a drafting workbench.Objective:To create the various part models from the 2D Drawings.To assemble the part models into a single component.To create the 2D Drawings of the components…

Attachment feature creation (Ribs and Screw Boss)Aim: To create the door handle component from the given class A surface.To create a tooling axis for the given class A surface meeting the requirements of the class A Surface.To attach B side features in the componentTo perform the draft analysis on the model.Creation…

Attachment Feature Creation - Dog HouseAim: Create a dog house for the door trim considering the design rules.Theory:Dog House:Dog house is a engineering feature used in plastic part design. Dog housed are used as support feature. Sometimes other engineering features like snaps, locators and screw bosses are mounted…

Door trim lower with engineering featuresAim: To create the door trim lower component through the given class A Surface.Objective:To make sure that the model meets the design rules for heat stake and locator creation.To construct a tooling axis and perform a draft analysis on class A surface.To create class B and class…

A Pillar Design With Master SectionAim: To create A Pillar design with provided master section with class A surface , create the tooling axis , engineering features (Dog House) and perform the draft analysis for the final solid part.Objective:To construct a tooling axis by using master section with bisecting method.To…

Final ProjectAim: By following the design rules and OEM standards create the door trim panel of CAD model considering the inputs given to me.Abstract:  The project deals with the explanation of steps and procedures followed while developing the door trim panel of car using CATIA V5. Using the class A surface, I was…