Use ADVISOR tool and simulate the following, 1. For EV_default_in file, if cargo mass is 500kg with all other default condition, can the vehicle travel for 45km with FTP drive cycle? Conclude your observations.  The figure shows the interface of the ADVISOR simulator using mathlab, Here as per the question the file…

1. What is the difference between mapped and dynamic model of engine, motor and generator? How can you change model type?              Mapped Model                  Dynamic model In mapped models, there will be lookup tablein which we entire…

1. Which type of power converter circuits are employed in electric and hybrid electric vehicles?   The electronic circuits used to control the powerflow in a circuit is called as power electronics. The components used in power electronics are power converters. Here a switch SW is assigned between a battery and a motor…

1. A) Explain a MATHLAB demo model named 'speed control of a DC motor using BJT H-bridge'. The above demo model of speed control of a DC motor using BJT H-bridge can be obtained by enterin the command 'power_Hbridge' in the command window. Here the DC motor will work according to the signal outputs of the BJT/IGBT. Here…

1. For a defined driving cycle, Calculate the energy required for braking. Braking of a vehicle is as important as acceleration. Acceleration is the increase in the speed and deceleration is reduction in the speed. We can calculate the energy required for braking in the same way we calculate the energy required for acceleration.…

Create a MATLAB model of electric car which uses a battery and a DC motor. Choose suitable blocks from power train blockset. Prepare a report about your model including the following: Objectives: 1) System level configuration. 2) Model parameters. 3) Results. 4)Conclusion.   INTRODUCTION: An Electric car is a car…

Project 1: Creation of user defined data type to implement the user interfaces for working with 'set'. (Mathematical Set Theory) Introduction: Head pointer: It points at the starting address of list. Tail pointer: It is a temporary pointer mainly used for traversing in the list. Newnode Pointer: It points to the new created…

Project 2: Implement the code for controlling the retraction and extensioin of Airplane's Landing gear Introduction : An airplne has three gears for landing: Nose Gear Left Gear Right Gear The hydraulic pump are used for exerting pressure to the gears to bring it down or pull it up and that pump is electrically driven.…

Write a Test plan to test features of a new mobile phone (Blackbox test) that needs to be implemented based on the following requirements. (The product is still under development stage and is yet to be UA (User Acceptance ) tested…

Project 1 - Controlling a DC motor using PWM and monitoring its Running status   Overview of the Project:  Implement a system on the simulator for controlling a DC motor using L293 motor driver, monitor its status and print the running status of motor on the LCD Display. Goals: Implement a system on simulator…

Overview of the Project:  In this project, the implementation of code for “Measuring distance of an object using ultrasonic distance sensor (HC-SR04) Goals: Measuring the distance of an object using Ultrasonic Distance Sensor (HC-SR04) Usage of Input Capture Mode Key Highlights of the Project:  Measuring…