1. Major elements in wiring diagram are:-BatteryStarterFuel GaugeAmmeterFuseIgnition CoilGeneratorDistributorJunction Block                                                         …

PREPROCESSING OF HOOD USING ANSA Aim: To extract mid-surface and generate mesh on Hood using ANSA Introduction: The hood of a car is called a bonnet. It's the part that covers and opens up to give access to the engine compartment on rear-engine for maintenance and repair. In recent times, car manufacturers have been working…

Aim: To extract mid-surface and generate mesh on CCB(Cross Car Beam) using ANSA Objective: The cross car beam(CCB) is the backbone of the instrument panel. From a structural perspective, the ends are mounted to the body walls and the firewall. This means there needs to be ample structural support for the steering column…

PREPROCESSING OF FLOOR PANEL USING ANSA Aim: To extract the Midsurface and generate a Mesh on the given Floor Panel by following the specified Quality Criteria using ANSA. Objective:  Generate mid-surface manually and perform geometry clean-up on the component. Generate mesh with proper mesh flow, with target element…

Aim: To create a Mid-Surface and mesh with the given quality criteria and to make sure the element given is free from geometrical errors. Methodology: The methodology for the given element is as follows: Perform a Geometrical Check ( if Errors present fix them) Extraction of Mid surface Assigning Thickness to Mid surface.…

Aim: To perform mid-surface extraction and then 2D shell mesh on the mid surface of instrumentation panel. Objective: To do geometry cleanup for the component. To generate the mid surface of the given parent component. To perform 2D meshing according to given quality criteria. To create PIDs for ribs, dog houses brackets…

AIM: To do geometrical clean up on the given component and mesh with the given element quality criteria. Use tria elements to create surface mesh and generate tetra volume mesh (unstructured volume mesh).  Objective: To check the geometrical errors on the Car Rear View Mirror model. To Provide Mesh Parameters and…

AIM : For the given Rear door model perform suitable connections for the FE model using ANSA.  OBJECTIVE : To give different types of connections for the rear door model of the car. These connections are given to the model using ANSA in the NASTRAN deck which will be used later for NVH simulation. THEORY : Door Assembly…