Week 8 - Challenge 2 - Switch Bezel Design

AIM:-Switch Bezel Design

OBJECTIVE:-

Create the Switch Bezel Plastic component through the given Class-A surface.

To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 2.5 mm

In order to obtain the proper draft analysis tooling axis is required and the following steps show how it is done.

- As this component has 1 hole from where the tooling axis can be generated, however, it does not have proper 4 walls to generate it.

In this case, an approximation is made in order to obtain the tooling axis.

- First by using the two side walls a dummy axis is made.

As it is known that the draft angle is 3 degrees, the second axis is taken as 3 degrees to the given wall and using these two axes the tooling axis is made.