https://drive.google.com/file/d/1Vt_9GkMfamPaZiMcMrEqn5qkP_8qswG8/view?usp=drive_link

https://drive.google.com/file/d/1fv2gziWaCuUoel8MosW2PfQjV9jjtO4D/view?usp=drive_link REPORT IS ATTACHED AS A LINK.

https://drive.google.com/drive/folders/1cxocoNzT3R7rIQ-Dva0qk1QSwVa0RHXu?usp=sharing

https://drive.google.com/drive/folders/1pagX54NDjlllJJhUqzxkB2BbghH2XIfD?usp=sharing

DOOR HANDLE TOOLING AXIS CREATION find a tooling direction select a point on a surface make a axis on the point  make a intersect on the middle plane then throught the draft lines make a line between there connecting points make a bisecting line from the draft line with the point that will be our tooling axis CLASS…

DOG HOUSE - DOOR TRIM TOOLING AXIS CREATION add a new geometrical set for tooling axis Initially create a point on the surface  then make a line that is on the y direction of the input axis then check with draft analysis that the class a surface clears the tooling axis publish tooling axis as well as class a surface…

DOOR TRIM LOWER WITH ENGINEERING FEATURES TOOLING AXIS CREATION for creating a tooling axis first we want to check the class a surface for a perfect tooling direction then create a point on the surface  then create a line with point - direction method and project a line using axis direction perpendicular to the surface …

ALL THE REQUIRED FILES, DATA AND REPORTS ARE ADDED INSIDE THE PPT. PLEASE DO CHECK THE ATTACHED LINK. https://drive.google.com/drive/folders/1-Ghe4pNmdWEa7ZtiNjDDz3Od-qyaKB0i?usp=sharing

FINAL PROJECT DOOR PANEL TOOLING AXIS CREATION for the tooling axis of the arm rest i had selected a point on the surface of the most posible tooling direction and created a perpendicular line with point direction method check the tooling axis is correct or not by doing initial draft analysis  and add a parellel line to…

HOOD DESIGN IN SIEMENS NX OBJECTIVE Design Hood Outer Panel, Inner Panel and the necessary reinforcements by following the Master Section mentioned with the Design parameters explained in the videos. A CAR HOOD  The car hood, also known as the bonnet in some countries, is a crucial component of a vehicle's…

SECTION MODULUS Section modulus is the ratio of area moment of inertia about the neutral axis and to the distance of outermost fiber from the neutral axis. The section modulus (S) is geometry property of the cross section used for designing beams and flexural members. It does not represent anything physically. S= I/Y S…

FENDER DESIGN Fender is the American English term for the part of an automobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Fenders are typically…