DESIGN AND MODELLING OF AMERICAN CHOPPER BIKE             Project report by:   S N V SRIKAR                                                                                        …

RADAR MAST    FRONT VIEW   TOP VIEW   SIDE VIEW   ISOMETRIC VIEW     FEATURE TREE             Assembly Yacht    Front view   Top View   Side View   Isometric View    Feature tree            …

                                                               …

  OBJECTIVE: Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.   ANALYSIS APPROACH: Before going to feature…

                                                 DRAFT ANALYSIS (SWITCH BEZEL)   OBJECTIVE: Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the…

Drafting analysis on door arm rest   Tooling axis creation Extract the base surface and create a point on the extracted surface. So using the point create a line in Z direction. Now, again extract the side wall surface and create a point on extracted surface. Using the point create a line in X direction. So these…

AIM Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. PROCEDURE CREATING TOOLING AXIS 1 at first check the part model…

OBJECTIVE: create core and cavity block for switch bezel.   Before going into analysis, we should create tooling axis.   Procedure for Creating tooling axis:   A reference point is created along a class a surface and using that reference point a new axis system is created. The X direction of the class A…