Photo Realistic Rendering
DESIGN AND MODELLING OF AMERICAN CHOPPER BIKE Project report by: S N V SRIKAR …
srikar snv
updated on 12 Aug 2021
Project Details
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by srikar snv (8)
Week 8 - Challenge 6 - Core & Cavity Design
OBJECTIVE: create core and cavity block for switch bezel. Before going into analysis, we should create tooling axis. Procedure for Creating tooling axis: A reference point is created along a class a surface and using that reference point a new axis system is created. The X direction of the class A…
24 Jun 2022 07:22 AM IST
Week 8 - Challenge 4 - Coin Holder Design
AIM Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. PROCEDURE CREATING TOOLING AXIS 1 at first check the part model…
07 Jun 2022 06:44 AM IST
Door Arm Rest Week 8 Challenge
Drafting analysis on door arm rest Tooling axis creation Extract the base surface and create a point on the extracted surface. So using the point create a line in Z direction. Now, again extract the side wall surface and create a point on extracted surface. Using the point create a line in X direction. So these…
28 Apr 2022 07:20 AM IST
Week 8 - Challenge 3 - Switch Bezel Design
DRAFT ANALYSIS (SWITCH BEZEL) OBJECTIVE: Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the…
12 Apr 2022 07:53 AM IST
Week 8 - Challenge 2 - Base Bracket Design
OBJECTIVE: Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. ANALYSIS APPROACH: Before going to feature…
06 Apr 2022 06:44 PM IST
Radar Mast & Final Assembly of Yacht
RADAR MAST FRONT VIEW TOP VIEW SIDE VIEW ISOMETRIC VIEW FEATURE TREE Assembly Yacht Front view Top View Side View Isometric View Feature tree …
20 Dec 2021 06:12 AM IST