MBD Simulation On a piston Assembly   Aim:- a)To design & assemble the parts in Solidworks.            b) To study motion analysis using three different conditions.            c) obtain the linear displacement of the piston head in all three cases.            Sr.no      Wrist Pin offset  crank speed(rpm)              …

simulation on an IC engine valve Train Aim:- 1)To Design the parts of the ic engine valve train & assemble them in Solidworks.           2) Run the simulation using the below parameter.              Sr.no cam lift (mm)  speed (rpm)   …

Frequency Analysis of a rotating shaft Aim:- To find out the critical frequencies of a rotating shaft in Solidworks. Objectives: design a model of the rotating shaft and conduct frequency analysis. To find out the 5 mode shapes & list the frequencies.  Introduction :              …

Aim: To study the flow over a cylinder using the Solidworks simulation feature for a baseline simulation & with a varying Reynolds number by a factor of 20%,40% & 100%. objective : calculate the Reynolds number for a baseline simulation. Run a baseline simulation. Run the transient simulation feature by varying…

Aim: - To Model Flow over a NACA0017 Airfoil & compare the Lift & Drag Force Using Different Angle Of Attack. Introduction:                  An Airfoil is the cross-sectional shape of an object whose motion through a gas is capable of generating significant lift such…

Aim: To study the flow bench simulation and select the best mesh size and run the parametric study on different valve lifts. Objective :  To create a 3D model of the Flow bench And Flow Analysis. Obtain Plot lift vs mass flow rate. To parametric study of valve Lift. Introduction:      An air…

Aim: Centrifugal Pump Design and Analysis. Objective :  A model Centrifugal Pump and Perform flow simulation Analysis. Obtain the relationship between pressure ratio and mass flow rate. Introduction:         centrifugal pumps are used to transport the fluid. A centrifugal pump is a mechanical device…