error during program-  

code :- % inputs % b = damping coefficient % g = gravity, m/s^2 % l = length, meter % m = mass, kg b = 0.05; g = 9.81; l = 1; m = 0.1; % initial condition, % initial displacement = 0 % initial velocity = 5 m/sec theta_0 = [0;3]; % time points % t_span is variation in the motion of pendulum t_span = linspace(0,10,500);…

A genetic algorithm (GA) is a method for solving both constrained and unconstrained optimization problems based on a natural selection process that mimics biological evolution. The algorithm repeatedly modifies a population of individual solutions. At each step, the genetic algorithm randomly selects individuals from the…

Aim: To write a code in Matlab to parse the NASA thermodynamic data file and then calculate the thermodynamic properties of various gas species. Objective: To write a function that extracts the 14 coefficients and calculates the enthalpy, entropy, and specific heats for all the species in the NASA thermodynamic data file…

Objective :- 1) Creating a Rankine Cycle Simulator & Calculating the state points of the Rankine Cycle based on user inputs. 2) Plotting the corresponding T-S and H-S plots for the given set of inputs   Rankine Cycle :- The Rankine cycle is a model used to predict the performance of steam turbine systems. It was…

Aim: To make a simulink model of a doorbell using solenoid block. To use a thermistor to sense the temperature of a heater & turn on or turn off the fan. 1.Door Bell Simulink Model: Simulink Model Explanation: The pulse generator is used to create square wave pulses at regular intervals.The block waveform parameters…

AIM:  1. Implement control logic of a "washing machine" using Stateflow as per given sequence: • If the power supply is available, the system gets activated. • If the Water supply is not available, stop the process & indicate through LED • Soaking time should be 200s followed by Washing time of…

AIM: To study the system level simulation of an all terrain vehicle. KEYWORDS: CVT, lookup table, Dashboard, baja ATV SOFTWARE: Matlab, Simulink OBJECTIVE: Study the baja ATV model without dashboard. Study the baja ATV model with dashboard. Study the baja ATV model using lookup table without dashboard. Study the baja ATV…

Aim: Mesh the Given component with the Size of 5 Units. Create 1D elements on the following component with the given cross-section and DOF a. Rod element:- Translational DOF should be Constrained with RBE2 link Cross-Section: BOX- Dimension a= 12 mm                  …

  Advance Meshing using HYPERMESH Week 6 Challenge Meshing Engine Hood using Hypermesh Objective: Clean up the hood geometry and then mesh the geometry with the target element size of 5 mm. Quality Criteria to be followed: Bonnet is the main component of a car at the front portion. It is used to decorate…