Challenge #22

 Challenges #21

Challenge #23

Challenge #24

Challenge #25

Challenge #26

Challenge #27

Chgallenge #28

Challenge #29

Challenge #30  

Challenge #31

# 32 FINAL PROJECT

Challenge #3

Challenge #4

CHALLENGE #11

PROJECT 1

PROJECT #2

CHALLENGE #1

CHALLENGE #2   UNDERBODY COATING – Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if you are getting the undercoating applied…

CHALLENGE #3   REPORT : DESIGN OF HOOD   INTRODUCTION - In this report we are going to study about Hood Outer Panel, Hood Inner Panel, Hinges , Striker in NX-12. Using the CAD we are going to design and develop the model with in safety conisderation.         HOOD - The hood or bonnet is…

SECTION MODULAS OF THE HOOD   OBJECTIVE - To find Section Modulas of Hood and optimisation to improve overall section modulas.   SECTION MODULAS -  Section modulus is a geometric property for a given cross-section used in the design of beams or flexural members.  It is the direct measure of…

CHALLENGE #4   REPORT - WHEEL ARCH AREA & ITS CALCULATION.   OBJECTIVE - The objective of this challange is to calculate wheel arch and to prove whether the given fender of the car will pass the European standards or not.   WHEEL ARCH - Wheel Arch is the semi circular part of the fender positioned above…

REPORT - FENDER DESIGN   OBJECTIVE - Design a Fender Model with the necessary mounting with a given class A surafce.   MOUNTS - 1. A-Pillar 2. Bumper 3. Sill 4. Cowl 5. Drip     FENDER - Fender is the American English term for the part of an automobile, motorcycle or other vehicle body…

REPORT - ROOF DESIGN   OBJECTIVE - Design a Roof, Front Roof Rail, Rear Roof Rail, Centre Roof Rail, Bow Roof 1, Bow Roof 2 with given Master-section and also check for the Heat distortation and Snow Load condition.   INTRODUCTION - An automobile roof or car top is the portion of an automobile that sits above the passenger…

REPORT - DESIGN OF BACK DOOR   OBJECTIVE -  Design a Back Door Assembly from the provided styling surface, use appropriate design methodologies and provide the necessary reinforcements and embosses.   INTRODUCTION - Backdoor are one of the type of door of the vehicle which are located next…