Make a Simulink model of Doorbell using solenoid block with the following details: Principle of Dorebell: The solenoid is an electromagnet with wire winding and small metal piston inside it. When electric current flows through the wire, an electromangnetic field is generated which pulls the metal piston toward…

1. Implement control logic of a “washing machine” using Stateflow as per given sequence:  If the power supply is available, the system gets activated  If the Water supply is not available, stop the process & indicate through LED Soaking time should be 200s followed by Washing time of 100s. Then…

Technical Report of Baja AVT   Following are the major compunent use in BAJA AVT Model. Signal Builder: Signal Bulider provide input to the model such as throttle, Break..etc Throttle: The device contrlled the flow of fuel or power to an engine. It use, Valve of requlating the supply of a fluid to an engine, especially…

1.   For EV_defaults_in file, if cargo mass is 500 kg with all other default conditions, can the vehicle travel for 45 km with FTP drive cycle? Conclude your observations. Sol: In below screenshot I have seleted EV_defaults_in file and change the wight to 500kg, All others parameters are as it is in default condition.…

Title: PWM Controlled Fan load Using DC Motor   Aim: To model fan type load in MATLAB/Simulink and control it speed using PWM method.   Theory: Modeling fan type load in Simulink with the help of PWM technique to control the speed of fan. We can vary the speed of fan with the help of PWM. The speed of the fan…

Title: Modeling of Electric Vehicle using MATLAB/Simulink   Aim: To model a most simple electric vehicle using powertrain block set.   Objective: To model most simple and low run time vehicle model using individual component model. To check out performance parameter: Speed, SOC%, Current, etc with various drive…