AIM:- CFD Meshing on Turbocharger. OBJECTIVE:-  Check for geometrical errors. Create PIDs. Assign PIDs. Perform surface mesh in the required target length. Blade stage-1 = 1 mm Blade stage-2 = 1 mm Impeller = 2 mm Shaft rotor = 1 mm Turbo casing = 5 mm Compressor casing = 5 mm Inlet casing cover = 5 mm Perform Volumetric…

AIM:- CFD Meshing for BMW car. OBJECTIVE:- Check and Solve geometrical errors on half portion of the model. Create and assign appropriate PIDs. Perform surface meshing in the target lengths as mentioned below in the element type as tria. Body - 3 mm Lights - 4 mm Grills - 1 mm Rims and Tyres - 2 mm Optical Rear view mirror…

AIM:- CFD Meshing for Tesla Cyber Truck OBJECTIVE:- Check and Solve all geometrical errors. Create and assign appropriate PIDs. Perform surface meshing with the appropriate Target length and element Quality criteria. Perform symmetry. Create and perform surface meshing on wind tunnel. Perform CFD meshing of Wind Tunnel…

AIM:  Simulate the flow over the Ahmed body and use air as the working fluid with velocity of 25 m/s.  Expected results: Velocity and pressure contour. The drag coefficient plot for a refined case. The vector plot clearly showing the wake region. Perform the grid independency test and provide the values of drag and lift…

AIM: Perform the heat transfer analysis using ANSYS-Fluent software for the given exhaust port problem and use air as the working fluid with velocity of 5 m/s. Consider Inlet and outlet temperature as 700 K and 300 K respectively. Take the wall heat transfer coefficient as 20 W/m2K. Expected results: Give a brief description…

AIM: Simulate the Rayleigh Taylor Instability using ANSYS Fluent. Expected results: What are some practical CFD models that have been based on the mathematical analysis of Rayleigh Taylor waves? In your own words, explain how these mathematical models have been adapted for CFD calculations. Perform the Rayleigh Taylor…

AIM: Perform a steady-state conjugate heat transfer analysis on a model of a graphics card using appropriate materials of your choice for the simulation. Make sure to properly define the correct solid and fluid zones. Run the simulation for the best possible mesh with a combination of coarse and refined mesh in different…

 AIM: Perform analysis on cyclone separator using Ansys Fluent software by varying the particle diameter from 1 μm to 5 μm and calculate the separation efficiency in each case. Discuss the results. [Use both the velocity as 3m/sec.] Perform an analysis on a given cyclone separator model by varying the particle velocity…

AIM: Perform a parametric study on the gate valve simulation by setting the opening from 10 % to 80%.  Obtain the mass flow rates at the outlet for each design point. Calculate the flow coefficient and flow factor for each opening and plot the graph. Discuss the results of the mass flow rate and flow coefficient. INTRODUCTION:…