MODELLING AND RENDERING OF AN AMERICAN CHOPPER BIKE  American chopper has been on television since 2003 and is one of the most popular motorcycling…

1. Radar Mast  Front view Back view Left view Right view Isometric view Feature tree     2.Yacht assembly Front view Back view Left view Right view Top view Isometric view Feature tree - mates     YACHT MODELLING AND ASSEMBLY BY USING SOLIDWORKS         AIM To create a 3d model…

Bench marking Benchmarking is defined as the process of measuring products, services, and processes against those of organizations known to be leaders in one or more aspects of their operations. Benchmarking provides necessary insights to help you understand how your organization compares with similar organizations, even…

Underbody Coating Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if you are getting the undercoating applied after a couple of years, it’s…

DESIGNING OF HOOD BY USING SIEMENS NX CAD A car hood, also referred to as a bonnet in some other countries, is the hinged cover that rests over the engine of a front-engine vehicle. Its purpose is to provide access to the engine for repair and maintenance. A concealed latch is typically used to hold down the hood. MASTER…

Aim: To Calculate the Wheel Arch gap at required points and check whether the car passes the European standard.  Fender Wheel Arch: Fender Wheel Arch is the semi -circular part positioned above the wheel of the vehicle. The most important body was a change that the front wheel arch was cut higher into the fender.…

ROOF CHALLENGE Roof An automobile roof or car top is the portion of an automobile that sits above the passenger compartment, protecting the vehicle occupants from sun, wind, rain, and other external elements.   DESIGN CRITERIA FOR DESIGNING ROOF Visibility criteria (front & back) head clearance…

  Section Modulus calculation and optimization of hood Section modulus is a geometric property for a given cross-section used in the design of beams or flexural members. Other geometric properties used in design include area for tension and shear, radius of gyration for compression, and moment of inertia and polar moment…

FENDER DESIGN AIM To design Dip area and mountings in fender by using given master section data. FENDER Fender is a metal or plastic enclosure over the wheels of an automobile or other vehicle to protect against splashing mud, etc. Importance of fender Car fenders provide safety to the driver and the passengers at the…

BACK DOOR DESIGN Aim: To design Back door of car and reinforcements and emboses by using the given styling surface. Back door: It is a hinged board or door at the rear of the vehicle that can be moved up or down during loading and unloading. Back Door is also referred as 'Hatch' or 'Tailgate' or 'Trunk-lid' or 'Boot-door'.…