Wiring harness routing & packaging Rules Week 3 Challenge

ANSWER1

The different stages involved in the design include

1.Get the 3D part.

2. Define the geometry parameters.

3.Define part as support.

4.Define bundle entry and bundle exit plane with entry points.

5.Define base plane and points.

The various stages involved are.

1. Use CATIA V5 to open the file after downloading it.
2. We specify entry, exit, base points, and planes using the Part design model.
3. Open the file in Electrical Part design after finding the points and planes.

4. Using the Define support Part command, we must now define the part as a support. Here, we employ the necessary planes and points to serve as the entry and exit locations for the clamp on one side.
5. Then, while maintaining the same base plane, use the support definition once more to provide an entry point on the opposite side by choosing the location across from the first support definition.

6. safe the file.

ANSWER 2

The different stages involved in the design include

1.Get the 3D part backshell.

2. Define the geometry parameters.

3.Define part as backshell.

4. Backshell connection point.

5..Define bundle connection points.

The various stages involved are.

1. Use CATIA V5 to open the file after downloading it.
2. We define two points as the Bundle entry and Connector connection point with Axis using the Part design model.
3. Open the file in Electrical Part design after finding the points and planes.
4. Using the Define Back shell Feature command, we must now define the portion as a backshell.
5. Once the Backshell has been established, the connection points must be established.
6. The Define Back Shell Connection Point Feature is used to define the end where the Back shell is attached to the connection.
7.End defined by the Define Bundle Connection Point Feature where the bundle is attached to the back shell.
8. Following the requisite qualities being given File saving.

ANSWER 3

The different stages involved in the design include

1. Create covering 3D part.

2.create catalog coverings.

3.Add new part in catalogue.

4.Add covering on harness bundles from catalogue.

The stages followed are

1. Launch the Electrical Part Design Model in CATIA V5
Using the Protection Definition Part
3. Choose Corrugated Tube as the type.

4. Provide the necessary parameters, including inner diameter, thickness, and bend radius (1.5 times the OD).
5. Press OK.
6. Following the requisite attributes, File saving.

COT 5mm

COT 10mm

COT 15mm

COT 20mm

COT 35mm