Week 9 - Project 1 - Door Trim Lower with Engineering Features

AIM:     Create the Pillar, Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. TOOLING AXIS: The Tooling Axis is the direction in which the…

Aim: To create a closed solid, Tooling Axis, Heat stakes,Dog House and locators for the given the given component.Input : CLASS-A Surface Door Trim Lower. TOOLING AXIS: The Tooling Axis is the direction in which the mould travels. The mold is built in two separate piece named core and cavity. Three methods for…

Aim: To create a door trim Plastic Component through a given Class A Surface and perform Draft Analysis on the final plastic component. Objectives: To Create a Tooling Axis. To Create Class B and Class C surface. To Create a solid part using surface modelling. To Perform Draft Analysis of Class A surface and final plastic…

  Aim:  To create a Door Handle Plastic Component through a given Class A Surface , perform Draft Analysis on the final plastic component and also Engineering Features Srew Boss and Ribs  Objectives: To Create a Tooling Axis. To Create Class B and Class C surface. To Create a solid part using surface modelling.…

AIM : To create the Core and cavity blocks for the Switch Bezel Component. OBJECTIVE : To Create Core, Cavity and Parting surface for the given component along the Tooling Axis. CORE : Core is a preformed, bonded, sand insert placed into the mold to shape the interior of a casting or a part of the casting that cannot be…

Aim:  To create a Base Bracket Plastic Component through a given Class A Surface and perform Draft Analysis on the final plastic component. Objectives:  To Create a Tooling Axis. To Create Class B and Class C surface. To Create a solid part using surface modelling. To Perform Draft Analysis of Class A surface…

Aim:  To create a Bumper Plastic Component through a given Class A Surface and perform Draft Analysis on the final plastic component. Objectives:  To Create a Tooling Axis. To Create Class B and Class C surface. To Create a solid part using surface modelling. To Perform Draft Analysis of Class A surface…

Aim:  This project aims to create a Coin Holder plastic component using the given class A surface following the OEM standard. and perform the draft analysis. Objective: To design Coin Holder as per automotive OEM Standard. Create B Class and C Class and tooling axis. Converting close surface into the solid inside…

Aim:  This project aims to create a switch bezel plastic component using the given class A surface following the OEM standard. and perform the draft analysis. Objective: To design switch bezel as per automotive OEM Standard. Create B Class and C Class and tooling axis. Converting close surface into the solid…