Aim :-  1) To write a function that extracts the 14 co-efficients and calculates the enthalpy, entropy and specific heats for all the species in the data file. We will be reading this file NASA thermodynamic data to obtain all the reults.                (the data…

Aim :-  To optimise the stalagmite function and find the global maxima of the function using MATLAB.             Plot graphs for all 3 studies and for F maximum vs no of iterations.                        …

Aim:- mesh the component with the following criteria given below and assign thickness.                                                                 …

Aim:- To mesh a Door Inner Panel for the following criteria.      Progression 1:- After carefully observing the geometry properly, the surface has a lot of ribs which helps us to deduce that it is a plastic component. Progression 2:- The auto mid surface option won't give us a good surface because of the ribs and varying…

AIM: To carry out a system-level simulation of an all-terrain vehicle using Simulink. OBJECTIVE: To prepare a technical report on BAJA ATV explaining model properties for the following:- without using the Lookup table                           …

Aim:    Implement control logic of a “Washing Machine” using Stateflow as per given sequence:           If the power supply is available, the system gets activated.           If the Water supply is not available, stop the process &…

Carry out the geometry cleanup operation on the given 3 files. Practice  Clip Repair Mounting Bracket Objective (1):-  Practice  Model The Cad Model Provieded.     The rest of the Surface was clear using the quick edit menu. The toggle menu was used the most  In one instance the filler surface…

Case 1:-  Rupture test 1   Epsmax failure Criteria The elapsed time for the simulation along with the energy error accounted for are given below.     Energy error    The energy error is .8% which is acceptable and less than 15% and the mass error is 0%. Hence the simulation…

Crashworthiness Analysis using HyperMesh and Radioss#Project 1 - Frontal Crash Simulation ChallengeAIM: To perform the crash on the frontal section of the car with wall and analysis where stresses are working on it. OBJECTIVES:Frontal crash-BIW1. Checking the unit system and either following [Mg mm s] or [Kg mm ms].2.…

#Project 2 - Side Body Crash Simulation ChallengeAIM: To perform the crash on the Side body of the car to a pole and analysis where stresses are working on it. OBJECTIVES:Side Body-BIW1. Checking the unit system and either following [Mg mm s] or [Kg mm ms].2. Creating appropriate interface, friction 0.2 and recommended…