AIM: To take the mid surface for all the components to the given hood model. And to check the geometrical errors and mesh the mid surface with the given element Quality criteria. PROCEDURE:  The Orientation of the given model is been changed as shown below.    The cons resolution is provided by the mesh…

 AIM: To take the mid surface for all the plastic bottle cap model. And to check the geometrical errors and mesh the mid surface with the given element Quality criteria. PROCEDURE: The Orientation of the given plastic bottle cap model is changed as per requirement. The cons resolution is provided by the mesh module…

AIM : To check for the geometrical errors and mesh the Surfaces with the given 2D element with given Quality criterias and to use tetra elements to mesh the Volumes defined in the model and check for the quality after Volume meshing. PROCEURE : The model which is given has many single cons, the model need a topo before…

AIM : To create different PID for the different component to the given rear door FE model and deploy connection to the given model. PROCEDURE : Different PID is created to the given model as shown below. Connections are deployed using the nastran deck RBE2 and RBE3 for the opening part repectively.  COG 3D point is…

..

AIM : To practice all the Morphing techniques that were shown in the video for Model-1 and to Perform morphing for the Model-2 and Increase the Height of the Dog houses and Ribs. PROCEDURE : MODEL - 1 Topo is performed to get the stritch the single cons into double cons. After Topo. The geomentry check as been performed. …

..

 AIM : To check for the geometrical errors and mesh with the given element Quality criteria for the given component and to assign thickness for the meshed mid surface. PROCEDURE: The given geomentry is not stitched properly. topo is performed. After topo. geomentric check as been done. Geomentrical errors as been…

 OBJECTIVE: To mesh the Given component with the Size of 5 Units and to Create 1D elements on the following component with given cross-section and Degree of freedom.     CAD MODEL IMAGE:     PROCEDURE: The geomentry of the given model is been checked. The cad model is cleaned using the auto cleanup…

 AIM : To clear the geomentry error of the given floor panel and to take mid surface, deploy mesh and attain the good mesh by clearing off with given quality criteria. PROCEDURE : Observed the given geomentry floor panel. Geomentry errors is cleared as shown in the screenshot below.     Distroted geomentry…