Stress Concentration on a Plate with Hole Assignment – Objective – The objective of this assignment is to perform design comparison on the 2 plate design cases. Design comparison will cover the stress and deformation comparison under the same load. The design with lower deformation and lower stress will be…

The design report and animations are attached for review 

Hello, Please see attached assignment for review alongwith the ANSYS file. i have tried Case 2 but need more support to understand User Defined Results. 

Please see the attached assignment for review  

Hello, Please see attached assignment report and ANSYS file for review

Hello, Sorry for the late submission Please see the attached submission files for review 

Hello, Please see attached assignment for review. 

Hello, Please see the attached assignment for review 

Hello  Please see attached assignment for review

Please see the attached assignment report for review and ANSYS workbench files as well. 

Long Piston with Cam Assignment Objective Transient Structural Analysis is performed on a Long Piston and Cam model for different contact conditions. The objective here is to understand the difference in the behaviour of the Piston and Cam for different contact conditions.  Design Model and Meshing There are 3 main…

Universal Joint Assignment – Objective – The objective of this assignment is to simulate a double universal joint with spring and performing transient structural analysis. The analysis is performed on 3 different materials and behaviour of each is studied under the same loading condition. Model and Analysis…

Worm Gear Assignment – Objective – The objective of this assignment is to simulate a worm gear assembly and perform transient analysis on it and plot the results. The analysis is performed on half section of the gear to reduce the simulation time and achieve finer mesh. Model and Analysis Set up Model Geometry…

Machining with Planar Assignment – Objective – The objective of this assignment is to perform explicit dynamic analysis of the machining operation done by the planar on a workpiece The analysis is performed on 2 different machining velocities and behaviour of each is studied under the same metallurgies. Simulation…

Tension and Torsion Test Assignment – Objective – The objective of this assignment is to perform tension and torsion test on a solid steel bar specimen using explicit dynamic simulation in ANSYS The analysis is performed on 2 different structural actions – tension and torsion and behaviour of each is…